1st Gen Lunchtable Thread - General Discussion

Would be alor easier to make it street legal. Doubt any shop will know what i did either.

Is it up todate on registration?

 

I’d keep the damn thing and slam it if California would let me transfer the Vermont tags over.

But I can’t.

Such is life.

 

Now you can slam the 90 pickup. Only 2k

 

For Indiana?

You better dip it in Titanium.

 

galvanized metal holds up fine out here.

 

Your state sucks

 

Theres a thread in the "other builds" section on here of a guy who did that to an 80 something toyota. This truck. Tacoma frame, powertrain and interior I believe.

 

Easy if you have a manual

 

Hmmm. This is tempting.

Be alot easier then trying to get a tacoma cab and building the frame.

 

I know what Perch is. The context of a leaf spring perch and the fish confused me.

 

I believe so. I shall confirm. I should know that haha

 

For Tyler? Was "shoot himself in the foot" apparently. For a normal individual 45 minutes at most

 

I’d buy a Miata for $2k

 

I saw that and I kinda wanna do that as a project someday. Be a lot more practical than a desert race truck in NC. Be alot easier to get parts for too.

 

At least I don’t need a radio mast to get decent internet service

 

Its registered. @BartMaster1234

 

That's because I live in the woods. I need something taller than the trees

 

Honestly? I’d say 5. You can do it in the truck but I elected to take the whole thing out.

Difficult part is actuallty disassembling the shifter mechanism.

Hardest part was I didn’t have silicone lubricant since my bushings are 3D Printed PLA. If I used anything with petroleum distillates, I would’ve dissolved the bushings.

 

It runs and drives!?!?

 

It’s not that difficult. I’ve done harder things. Trying to line up the A340F dowels pins on the bellhousing with the engine remains one of the hardest things I’ve ever done. I never want to do that shit again.

Cue everyone saying “That’s not even that difficult.”