What Have You Done To Your 3rd Gen Today?

Finalizing some new Tacoma aluminum offerings.

 

Looked at pictures before reading...

Whoa... This mofo loves his chrome, holy...

 

Greased the balljoints on my SPC UCA’s. Did 10 squirts on each side.

 

I would get rid of that plastic bumper cover below the license plate too. I cracked the one on the '16 SR5 I traded just by using it as a step to get in my bed. I won't make that mistake with my new SR.

 

Huh, haven't had any issues with mine.
This bumper is for the guys that want to add some protection and recovery points without adding weight and keep the factory look. Not for everyone but should be a good option that is currently not offered.

 

No chrome, all aluminum prior to coating. This will all get coated black.

 

Yeah I'm with ya. Looks good. Just speed browsing on the phone

 

Nice pic. Looks like a Christmas card.

 

Hey! Just curious where the tailgate vinyl is from. it looks great on your truck, I've never seen it before!

 

This is actually my customers truck.
I'll see if I can find out.

 

If you could that would be really great!

 

Adding a dual battery system to prep for a winter camping trip through the southwest between Cali and Texas and back over the holiday, going to use it to power up a portable 12v forced air vented diesel heater unit to keep the RTT toasty when out of the sleeping bag.

My heater is similar to this- be sure to get one with the mufflers if you pick one up:https://www.amazon.com/diesel-Heate...sel+heater&dpPl=1&dpID=51W7Y5Ct0gL&ref=plSrch

 

I installed some Ogfab molle panels on my front doors and center console.

 

Install was ok, Nothing wanted to line up perfect so a lot of pushing and pulling. And the roof has rubber tape over the holes, so I just cut enough room in the tape to let the screw go in, It's pretty sealed up it has weather stripping on the rear and a huge base plate thing to seal. But I am going to dab a little silicone on there.

 

3'' ready lift, and 2'' wheel spacers no rubbing. Only trimmed a Little piece of fender plastic.

 

Try these bob

 

Where did you buy these from cant find them anywhere

 

Tacoma beast

 

Doing well, sir.

Thanks for asking.

Hope all is well with you, the family and Mr Riley.

i'm up early this morning and testing the waters with my back. Took the last couple days off, doing a shift swap with a coworker. I was hoping to let the steroids and other meds kick in and get this flair up under control. Happens every couple years, it seems. For whatever reason this time around the relief has been a bit slower.

I'm grateful for the heated seat covers right about now....that heat is therapeutic. I'm thinking about going a step further and getting a full on medical cover that conforms a bit better, heats & massages. I haven't shopped around but know they are out there.

My Tacoma is in serious need of a wash and wax. Weather has been poor lately and then this last week the back thing showed up again.

All will be well.....time to grab another cup of coffee.

 

Like that back bumper. Able to still use the factory receiver hitch.