Taco lean. Options.

So I've adjusted the front drivers and im at the point that preload is decently different. Has anyone ever just run a single rear leaf spacer in like .25" or .5" increments?

 

Take her out on a date.
P.S. Have a spare coil-over just in case.

 

Just how the hell did you get a pic of my sister?

 

I have a 1/4" spacer on my driver side. No preload (OME 884 springs)

 

Where did you purchase this? I'm running a 2.25" spacer lift (god forbid i know) up front. Wonder if an additional 1/4" spacer can be done on the driver side only...?

 

Don't knock it bud... Might just be alright!

 

Im not talking about running up front, my front is level the rear sits uneven and was going to run a small shim/spacer under the leaf pack to adjust.

I'd rather have preload even upo front and slightly off out back than an excessive front preload to the rear

 

I think I’ve seen them at wheelers or headstrong? Can’t remember for sure. Yes this can be added specifically to offset the taco lean or the bbc lean. You just may need longer bolts or studs- whatever your spacers have

 

Headstrong

https://www.headstrongoffroad.com/store/c118/Spacers,_Top_Plates,_Brake_Lines,_and_Hardware.html

 

Thanks gentlemen!

 

You do leafs? Try loosening at front and the 2 points at the shackles. Move back and forward loose then re tighten. I've heard of over tightened leafs binding and creating a false lean.

 

i haven’t checked them yet. i’ll look at that.

 

Im guessin from her brother..