FS: Morimoto LED AMBER Fog Lights **PREORDER GB**

Maybe hard to see in the daytime but they seem to match my rigid LED perfect.

 

Looks good, I remember the light from mine being a little lighter in shade, but it was over a year since I've seen them and could be wrong!

 

Ordered! Along with my TRD Pro grill and amber raptor style lights! Christmas was good!

Also, my first post on the forums!

 

Right on , purchased the same stuff

 

Welcome to Tacoma World! The site that is sure to put a dent in your wallet.

 

Tech tip: 12v power was the green wire on my 2018. Connect the red wire from the fog light into the green wire on the oem harness.

 

I hear that. I was online lurking the day I got the truck.

 

Confused? Aren’t these simply plug and play, right into the factory fog harness?

 

They are but you have to insert the pins from the fog light into the supplied connector. If you don’t get the polarity right the light won’t turn on.

 

Thanks for that,haven’t had time to install mine but have a 4 day weekend coming up in t minus 2-3 hrs

Yes but you have to insert the fog light wires/leads into to provided plug because it’s capable with multiple vehicles (I heard) but the wires might be different between them all

 

Ohhhhhh ok. Got it. Thank you!

 

Ordered mine on the 23rd! Can't wait to get them installed!

 

Got mine installed finally! Pics to come once the Raptor lights are done

Pro tip: make sure to come in from the top/grill than trying to bend back the fender liner. Muchhh easier and makes alignment after the fact a breeze.

 

Honestly, I was hoping to do it from the top/grill, so that’s great to know. Any issues alignment wise? How hard would it be to align them from that angle? Can’t wait to see the pics.

 

I did it from the top without removing anything. The lights themselves fit just like oem, however the adjusting screw is pointing down while it points up on the oem fog lights. If you need to adjust the beam you have to do it from the bottom.

 

No alignment issues, they are straight and level, just like OEM.

Note that there are slots the tabs on the lights tuck into. Only 1 screw is used, although there are 4 screw holes. No need to try and create additional holes like I did. THAT will mess up your alignment (toed in).

 

I went from the top down as well, total time to remove factory and install these was maybe 15 mins. Mine were pointed way to low out of the box, and I was still able to put my arm all the way down from top and use a stubby screw driver to adjust, it’s still a touch too low but they are a dark amber output not like the normal “yellow” many are use to, I like them and I was worried they were not going to be enough but paired with my 5500k hid low’s they work just fine in fog/rain conditions. Glad I held out for these instead of picking up the white Morimoto fogs

 

Same on the sr5, don’t put the wrong pins in, i did at first and blew a fuse ¯\_(ツ)_/¯

 

You DO NOT need to do it from the bottom. You can fit a stubby screwdriver in from the top, and use it upside down. Then adjust from there, super easy once you get the screwdriver into it's slot.

They only give you one screw but I used two. I used the new ones they give you, plus the one from my old ones, seems super sturdy. I used the screw holes on the outside of the fog housing for both.