What Have You Done To Your 2nd Gen Tacoma Today?

Close up

 

Retired the backflip and bought a used leer cap. Black cap on SSM truck don’t look too bad. Helps though with the high clearance black bumpers all around

 

Looks great Matt love the Coops

 

Hey brother I just installed DEPO headlights as well on my 06. Did you have an issue adjusting them? My right one is pointed way up and I tried messing with the so called "adjustment knobs" but couldn't see any noticable difference.

 

forgot to take pic of the finished product lol ill add later. anyone else use flexidip before? turned out good, but i think ill try plasti dip for the side emblems. I also think i may plasti dip the chrome on the grill black (but leave toyota emblem chrome). Thoughts?

 

I installed DEPO headlights yesterday. Adjusting them was a pain in the ass but mine DID finally adjust. Just keep turning the adjusters. The outer/lower knobs move the beam up and down, the inner/upper move left & right (barely)...It takes A LOT of turning to get them to move a minuscule amount. Most annoying part of the project by far imo.

 

Thanks for the info!

 

hows the brightness/vidibility with these?

 

No complaints thus far. Adjusting the beams correctly is crucial though, obviously. They seemed really weak until I got the beam direction dialed in. Still messing with them a little but I'm impressed so far.

 

Thank you

 

Found a guy on Etsy that does vinyl decals, estimated custom dimensions for one of his designs to integrate with the TRD logo, and had a tint/vinyl wrap shop professionally apply it.

Baby steps.

 

Link to the net?

 

Installed redlines , and coverking seat covers

 

just went out for a drive earlier and they are aimed a little high im gonna try and adjust em and see how that goes. have you had any condensation issues? I haven't yet knock on wood. but was just wondering how reputable these are.

 

None yet, I used silicone sealant around the edge to try and keep the moisture out as best I could.

 

I did too as well, hopefully it does the trick

 

Yesterday ujoints and 3degree axle shims turned out the noise is a bad yoke. So I greased it put a zip tie on no more noise now hopefully while I’m in Colorado I can find a driveshaft for a RC but no luck so far without buying a new one which is what I may have to do. Hope my yoda limps home and makes it to mid month pay day then I can have a greasable driveshaft made. Yes I greased all my zerks but the slip yoke was not greasable.

Also bought a 9k badlands winch I’m going to try to fit into my ARB bumper and a new farm jack.

 

Led third brake light

 

Whered you get this switch setup from? It's super clean...I like it!