CBI T3 front bumper install...

I received my T3 bumper.

 

Man, you’ve got this, it can be scary. But it’s totally worth it. Go slow, measure a couple times. Tape it off, walk away, come back and re-check it, drink a beer. Fire up the chain saw and cut it!!

 

Use an angle grinder and a big disc to cut through so you have less jagged cuts. Piece of painters tape over where you cut will protect the paint. Always go less than what you think you need to cut so you can cut more if need be. Also you can always adjust the bumper up and down if your cut is low or high.

 

I will do the

 

I used a jigsaw with a fine blade and went slow.

 

Are your oems fog pretty flush with the bumper? The bracket they provided to mount them made them sit kind of far back on mine.

 

My cuts sucked and I wasn’t even smart enough to throw some trim liner on the edges like my rear high clearance bumper. You got it bud just take you time! At the end of the day it’s only plastic. Installing a snorkel is way worse...

 

Have been looking at bumpers for a while, and I chickened out reading this thread.

 

How does this picture make you feel?

 

I would buy a

 

How long ago did you order? I ordered sept 21 (t3 aluminum) and still waiting-

Hopefully I am close

 

I placed my order

 

My cut

 

Any chance you have videos or pictures of it all- seems that is incredibly lacking... I am nervous about the install also

 

How did the cutting go? How’s it look? From the pics it looks like it turned out good.

 

More pictures please, I've never seen the T3 with just the tall center hoop before

 

Finished