Wheel Bearings & Hubs Press Service *** OE NSK ***

Received, Thanks! Now I need to find the time to do the install

 

Did you guys torque down the bearing assembly bolts? I could only fit a wrench in there, and I don't believe a socket would even fit in between. Looks like its supposed to be 59 ft*lbf. Mine's making a slight noise each rotation, maybe mine didn't seat completely right (my fault/first time installing this).

 

Make sure to clean out the spindle of any dirt/rust before installing. Use some MP synthetic lube on the o-ring and make sure it seats evenly. Blue lock tite on the 4 bearing assembly bolts and use a box end (or similar closed end) wrench to torque them down good and tight. I rechecked these bolts after temporarily installing the axle bolt and then again after a few miles of driving to seat everything.

Make sure that the axle bolt is correctly torqued. Any binding might be due to over torquing.

 

To do that properly you’d need a torque adapter.
The bolts come with a lock tight type coating on them already, no need to add but if already did probably wouldn’t hurt.

 

I got a bunch of parts to rebuild front end like the upper/lower control arms, inner/outer tie rods, sway bar links and am eyeballing your hub assemblies. While I'm doing all of this I was considering doing the axles and if I do so, should I be doing anything else past the axle on the diff side? If it helps I have a 07, 4x, 4.0, Dbl cab, Sport with 185k. Thanks.

 

I'd consider these things:
CV outboard dust seal 90304-A0001
ECGS bushing
Carrier oil change

 

Ordered some from this fine fellow. Hoping my left front bearing can hold on until they arrive haha.

 

I just "started a conversation today". Front passenger side is growling like crazy and at lunch to day I jacked up the front and found ~.5" of play in the 6-12 o'clock position. Hoping it will last until I receive the parts.

 

Replied

 

Part # or link please.

 

$23 ABN Bearing Race and Seal Bush Driver Set with Carrying Case – Master/Universal Kit for Automotive Wheel Bearings

https://www.amazon.com/ABN-Bearing-...ns&keywords=bearing+and+seal+driver+kit&psc=1
You can also rent them from a local parts store. These are good for doing the seals just gotta match the right size up.

 

@wentz912
@SilverTaco21
@Iggy
Shipping today

 

@lo2hi I would think a crows foot would be the appropriate tool to use for getting those bolts torqued.

 

Nice! I was wondering about the name for those adapters. I did both wheel bearings without them, and just got them nice and tight.

 

A crow's foot won't clear the torque wrench head from the hub, you would need a Torque Adapter (extender) and math to do it by-the-book

https://www.engineersedge.com/manufacturing_spec/torque_wrench_1.htm

 

@67 Series IIA
@jross20
Shipping today

 

Math...Where the nerds at?!

 

What am I missing here? lol

 

Nothing, I was just being random.

but anyway, I've been told that if you use a crows foot at a 90 degree angle that it really should not affect the torque settings. no it with that being said I would probably use the shortest one possible at a 90 degree angle and take it with a grain of salt.

Obviously if you use a crows foot straight on and extend the length of the tool that will affect everything