What Have You Done To Your 3rd Gen Today?

Picked it up from the salon. I'm very happy with the treatment it got.

 

Nice! Thanks for sharing

 

Nice set up. In a roll over those things look like they would come loose and cause more issue?

 

Do you happen to know what kind of vinyl they used?

 

No worries! Thanks for the product. Not the slightest bit disappointed with it. Any recommendations for a compatible top-rack spare mount for it?

 

Always nice to see another Kayak fisher

 

Probably. TBH anything not bolted down will escape in a roll-over.

 

Looks great! BZ.

What is the model of those vent shades /rain things in your windows?
Thank you.

 

I used a 10mm I believe. Took 10mins, super easy and quick.

 

Those are the AVS in channel rain guards. I wiped the logo off with laquer thinner.

Thanks! It needs a real wash....

 

Thank you. I'm gonna order them. They look good. And make sure you give it a good scrubbing! hah.

 

Awesome

 

My KB Voodoo awning brackets wouldn’t clear my RTT. So I had a 6” horizontal bridge fabbed up.


Finished mods were bedlined.

And mounted.


And my awning is finally mounted.

 

Washed it. Again. Wash # 2628482651839 in 20 days of ownership. We had snow, then it melted and it was a mess. Then I installed CaliRaised brackets and 32” bar. Shout out to them, I had originally ordered the kit for my 4Runner and totaled it before the kit arrived. They happily and quickly exchanged the brackets out for me. Nice pieces. I still have some other electrical I want to do so I’ll wire the light at that time because I want to take the dash apart once and be done.

 

All I did to mine today was take a couple pictures. It’s too cold and wet for much else.

 

Just what I need, I’ll send you mine! What’s the cost? Either that or they just play paper weights for a few more months!

 

Scored one of those fancy glovebox organizers. I have to say, in almost 20 years of modding cars, this may be one of my absolute favorite things I've ever purchased for a car.

 

Not today, but last weekend:

@CaliRaisedLed bolt on 25 degree sliders with kickouts

And Diamondback SE cover.

 

I didn’t do the cut and weld. It cost me $20 and some Shiner.

 

We don't offer any tire mounting solutions but the rack has quite a few tie down locations. You could purchase a Y-strap and easily find 3 tie down points

It's possible you could bolt a bed mount y-bar to the rack although we haven't seen it done yet

Relentless Fabrication
www.relentlessfabrication.com