Passenger Door Smart Key System

There’s information in this thread about that.

 

I thought so, but searching is failing me, so that's why I asked.

 

Yes, you can use the Carista app

 

What I used

 

So just to clarify, only way to do this is to make “all doors unlock” in the settings, does that make all doors unlock when just grabbing drivers door? Do they also all unlock with just a single press of the key fob or does key fob function remain factory like function, one press for drivers, 2 for all doors.

 

All will need to unlock when touching the handles, but you can keep the settings the way you want with the key fob buttons. (Two separate settings for key fob and touch sensor)

 

OP, how come 2 different terminal numbers? 82998-74030 & 74040

 

Wire color

 

How are the wires routed for the handle in the driver's side? Anyone have a visual/pic? Difficult to duplicate the routing in the passenger side, instead of dropping the wires down the void?

 

I don't have pictures, but I did have the drivers side open at the same time to replace the speakers. The wires are attached to molded plastic pieces and if I recall they were routed to the inside of the door. It would be difficult to duplicate without the equivalent plastic pieces.

 

I'll post some pictures of how I routed the passenger side. I don't know what the driver side routing looks like, but all that really matters is you avoid the window track.

Wires at handle zip tied:



From the handle going downward (wires not soldered yet in this pic), I used the door framing to zip tie:



Then there's a tubular cross member within the door near the bottom, beneath the window track, that runs towards the door boot:





Cross member as seen through the speaker mount hole:



From the end of the cross member, I tip tied again to an opportunistic hole to lead the wires up to the factory harness:



Then through the door boot:





The rest is pretty well documented in [OP]'s post.

 

You should really cover those wires with something. It’s not a good idea zip tieing wires to metal. Wire loom or even wrap them in electrical tape for some protection.

 

If I ever have problems with my antenna door handle shorting through the insulation, I’ll go in and fix it. Given how many people have done this mod without issue, and without mentioning wire looms for in the door, I think it’ll be fine.

I’m just the guy who shared more detailed photos. Don’t pick on me!

 

I didnt want to worry about that either. Pic before i cut my zips so you can see that last one at the back to keep the window chanel clear.

 

How hard is it to get through the door boot? Some vehicles are pretty tight

 

Shit Homer! That's too damn clean. You need to dirty that up a little and stop making us look so sloppy.

 

Almost had a heart attack looking at that pic. Uncut zip ties....... but you said you cut them. WHITE zip ties though

Honestly, I'm not trying to pick on anyone here. I'm anal about wiring due to my 20 years of experience in the 12 volt industry. I've seen so much dumb shit done with wiring in vehicles that I wish I could show people better ways to do things before they make mistakes. Wiring issues can be some of the most frustrating issues to figure out.

 

I'll definitely keep your advice in mind. It would be easy enough to loom that ~6 ft of wire.

 

I removed the boot on both the door and cabin sides (the ends are essentially rubber grommets), then pushed a wooden skewer (from the kitchen) through while keeping the boot straight. Once the skewer was through, I taped the wire to the skewer and pulled it right through the boot. Then I pulled all the excess wire through and replaced the boot on both the door and cabin sides.