DomeRock Module for Courtesy Rock Lights V4 by DSIM Solutions

In for v3 when ready. ❤️

 

Also in for a module when available. Should we PM you OP to get on the list of power?

 

Following the MESO approach. When available there will be a paypal button on first post. First come first serve. Ill usually give notice before a drop.

 

Awesome. Thanks! Looking forward to it!

 

I am down for the one of these. Was researching how to do this and bingo, you have done it. Sub’d

 

In for V3 =)

 

Still working on getting harnesses in. Hoping soon.

Soon as i know ill update you all. Patience

 

I'll prepay first if need be lol. Don't want to miss out heh

 

That works like a charm...

 

sub'd for v3

 

Need.

 

Yes, I need one of these as well. Any idea when another batch will be available?

 

Still waiting on T-Harnesses. Will update you guys as soon as I know. Thanks for being patient.

 

This looks sweet. In for the next batch!

 

One module will power two sets of the lights that you linked?

 

My understanding it that it's not driving the lights, it's basically just an additional switch that triggers on signal from the 'yellow wire' door light activation and then in a proper relayed light set up tells the relay to close, which then powers the lights.

I'm lucky I have a couple additional relayed circuits ready for expansion with my tacoma pro's fuse block, I just need to figure out another switch mounting location.

 

Previous version the Relay Coil + (85) and the Comm (30) are connected together and ran to the battery. Then 12V+ OUT (87) was ran to either A) For high draw situations the Relay Coil + (85) to "trigger" the relay powering the lights. Where the module is more of a trigger. B) For low draw (Less than 3A) it is possible to drive the lights directly from the module. I ran that setup for a long time.

The difference with the new version is with the T-Harness we will be getting out Constant 12V+ input from the cab as well (one less wire run and tap to worry about.) However in this scenario I would recommend using (A) from above and it may even be necessary because there are other lights running off of that circuit (dome lights), I'll need to check into that. It is always a good idea to run a relay to drive the lights where the source is directly from the battery. Then my module is not driving the lights, it is just a relay that is "triggering" the other relay that is "driving" the lights.

Hopefully that makes sense.

 

Makes sense. To summarize, if I send the power to a relay then one module should easily trigger 2 sets of the rock lights?

 

Still using DSIMs module to trigger my custom puddle light setup. Circuit is tied into my floor lights which also has an on/off button in the cab in case I want to turn on the lights while driving at night. Also just installed another one of DSIMs modules in a friend's truck over the weekend.

 

Such a dope rig man.

Working on finishing up the first batch while I wait on the T-Harnesses. This will be plug in play minus the splice into the existing rock lights setup (Purple Wire). Heres some shots. Wish I had MESO's 3D printer but it will do the job.