Tacoma - OVTUNE - VFTUNER - Update Info and Original Development

Gotcha......just wanted to make sure. Interested to see what resetting the values does.

 

It varies. Some have gotten them quicker than others. Depends on stock on hand and how busy Mat is.

 

Thank you. I'm sure he's busy.

 

Congrats man. It’s worth the wait. Remember this moment before you have the tune. Remember everything about how the stock tune drove. These memories will be of service to you in the future when you can’t wipe the smile off your face, because Being OVTuned has a tendency to make us forget how our trucks drove stock

 

Just replaced my crankshaft position sensor and drove my truck. Got 1 misfire where I normally would have been between 10-15 (sometimes way higher, NEVER LOWER). I’m cautiosly optimistic, but my misfire worries may be behind me.

When I pulled the old sensor out, I noticed what looked like scratches on the face of the sensor. The part I replaced it with was part number 90919-05098. It’s the one with the “=“ stamped on it. The one I pulled out had the hash mark stamped on it.

Holly crap guys... I’m trying to stay cool about this in case this was an oddball drive cycle. The fact that I may be able to drive my truck without worrying about this any more is a game changer.

 

Brotherhood for sure. Thanks.

 

#Tacomabretheren

 

So I installed the tsb and went to o4b04 but when I try and flash the 91 gearlock file it says completed unSuccessfully is there something I’m missing? I flashed through the flash manager

 

Good to hear. Keep us posted after more drive cycles. Did you notice any difference while driving? Especially low RPM high load scenario. Smoother idle?

 

I live in Portland and 92 octane is the highest I can find. Have you seen any 93 octane around? I heard a rumor Spaceage gas stations have higher octane gas and non ethanol.

 

so i downloaded tech stream 13.00.022 and the crack you provided but im stumped how to get past registration part..

instructions say "open techstream and select area and then close" how do i do that exactly? confused

 

Did you follow all flash instructions? Truck ignition on, engine off when flashing via flash manager? How many KB (size) was the 1.05 tune file? We're you able to identify the ECU?

 

I was able to flash sucsefully.

 

NOTE: FOR ECU VERSIONS (AUTOMATIC) 04B02 and 04B03 PERFORMANCE AND GEARLOCK FILES ARE STILL PENDING UPLOAD. They will not be downloadable quite yet! We are working on getting them up asap.

Any ETA on the 04B03 Performance and gearlock files? 6900 rpm has me anxious

 

I’m telling you 6900 rpm and throttle response is so awesome scared to to open it up it’s pouring here and it spins those rears with no hesitation

 

And I think he said something about this week. I couldn’t wait so I did the tsb and flashed the 04b04 91

 

Put it in 4 wheel drive!

 

if I keep traction control on it’s pretty safe. But I can see why some might complain about the tip in. But I love it. This is how the truck should be. This tune with 4:88 will be perfect if not to much to handle

 

Thanks guys, I believe I did the tsb right?

 

I copied and pasted the long number that’s shown in the directions. If no-one chimes in by tomorrow morning I’ll try and write it all out here as best as I can remember it.