What Have You Done To Your 3rd Gen Today?

Here is a mod for you...

$38 ThisWorx Car Vacuum Cleaner - Car Accessories - Small 12V High Power Handheld Portable Car Vacuum w/Attachments, 16 Ft Cord & Bag - Detailing Kit Essentials for Travel, RV Camper

https://www.amazon.com/dp/B06ZY896Z...colid=APEQSY3XEU1A&psc=0&ref_=lv_ov_lig_dp_it

Very nice bed liner, I like my Bak series as well. How you liking 10" sub, just had a JL Stealthbox put in and really liking it.

 

that's pretty slick!

 

Nice

Thanks!!!

 

Let us know performance wise?

 

Thanks It is a pretty easy mod to do. If you already have a power line run to your console you just run a standard relay from the power adapter in the console to activate it on run or acc. Then you run the new line through the switched side of the relay and to the back of the console with a 1.15 inch hole (for this power adapter.)

It is pretty easy to remove the two panels with a panel tool. First you remove the upper panel by removing the shifter knob and loosening The parking brake shroud. Then you pop the panel straight up using a panel tool and gently disconnect the power cord. The rear console box has two 10mm, of course, bolts holding it onto a bracket under the carpet. After that you just wire it up and you’re good to go.

 

I love mine back there, great light when you need it!

 

I did my bracket and compressor install over the past couple weekends. Ended up taking it out and mounting the compressor several times to get it the way I want. But way easier to mount compressor on bracket, then install them together in the truck.

 

Yah! Those trips to the mall reek havoc on floor mats!

 

Very nice. Love the switch. Is it waterproof?

 

No it is the switch from Arb, actually looking for a better switch option, but now with bracket, will be easy to switch out

 

Installed this bad boy today....very easy, perfect fit and exactly the sound I was hoping for. Slightly more aggressive than stock but not obnoxious and no drone.

 

Me too. I did a toggle with cap and so far so good but I want a perfect solution. Cap may not be in this picture. I too messed around with brackets and installed it all at once. These compressors rock.

 

Sound clips or it didn’t happen...

 

Yes first time I actually installed one, always used a plug in before, love the setup!

 

Why are the cool mod sites always sold out of everything for months at a time, then they make five and the vultures swoop in before I get a chance to even visit the site.

I’m talking to you, MESOcustoms and Runnin4Tacos!

 

That’s a lot of work. Just trust me. I wouldn’t lead you astray.

 

That's a great idea. So did you use 2 of these side by side and did you just use the tape backing to attach to the top of the housing above where the festoon adapter goes in?

 

This weekend I installed on my '19 OR:

Front: Bilstein 6112 shocks/springs and SPC upper control arm
Rear: Bilstein 5160 shocks and Wheelers add-a-leaf
All purchased from Wheelers Offroad, of course.​

Resulted in 2.5" front lift, 2" rear lift, and ride is more firm and controlled.
Next up: 4Runner Pro SEMA wheels and 275/70/17s. Have them but need to get them put together and installed. Oh, and an alignment! Also have CaliRaised sliders on order.
Here are before/after shots:

 

How close are they in color to the runner lights?

 

If I do this. I would consider painting the brackets to match the truck.

How many times did you get barked at before it was co-pilot approved?