FS-Custom 2, 3, 4, 5, 6, 8 and 10 switch plates

I’ll PM you.

 

I would be curious how this will look as well? Or could it be done?

 

Yes it could. It would take some trial and error. If I had a spare center console to cut up for prototyping, I could easily do it.

 

Count me in too! Please thank you.

 

Did you ever go through with this? If not I can send you a picture of mine.

 

I was never provided a pic.

 

Here you go bud. Sorry for the mess, my girlfriend is detailing it Sunday.

Did you design one for that front cubby? I thought I saw one when I was skimming through all 15 pages

 

There's one where a customer ordered two double switch mounts and he mounted them in the front cubby with a dual battery monitor. That's probably the one you're thinking of. The way yours is set up, you could probably fit a single switch mount on the upper right corner, a single switch mount on the middle left, and a double, possibly a 2 x 2 in the lower right corner.

 

What are the dimensions of the 2x2 and 3x2 if you don't mind me asking? I'd be alright with getting rid of that smaller cupholder for a switch panel.

 

The external dimensions of the 2x2 is 61mm x 81mm. The external dimensions of the 3x2 is 61mm x 117 mm. Just to clarify, the switch panel can't replace the cupholder.

 

That sucks. I was hoping it'd be an easy cut out job. Any particular reason as to why?

 

I mean that in the sense that if you a switch panel and it’s not bigger than the cup holder, then it wouldn’t look right. If you can give me precise measurements of the cup holder itself, I can see which switch panel would cover it. If none of my current switch plates fit, I can custom make one for you. PM me to discuss options further if you want to go forward.

 

Just a reminder about this good idea I would like this in my truck some day!

 

I'd also like to support this idea. I'd buy one immediately.

 

I would also like to support the idea being supported by the supporter I’m quoting...

 

Where is a good place to get custom switches that fit these? I got the 6 switch vertical panel

 

I got mine from aironboard.com

 

Just finished this up today, love it. Looks so clean. Factory finish

 

How is it held in? Glue, press fit, snap in?

 

Snaps in