What Have You Done To Your 2nd Gen Tacoma Today?

It is available for purchase, but my boy Dave has it, therefore no need for me to add to expenditures. So, I'll find out where he bought it from. You can alter a variety of features on your vehicle with it by the simple click of a mouse. It's quite awesome. Check back soon and I'll have information.

 

I am more of an mechanical and less of tech guy. I don’t know how to software

 

Holy F**k no way! So doing this mod tonight!! Thanks dude

 

I hope this works on my 2014

 

It's simple. A quick overview of Toyota Tacoma electrical schematics will outline a solid road map for your programming needs. Once you hook the leads of either a fluke 787 or 789 with optional analog sourcing to the appropriate fuses on your truck, you're 25% of the way there. Then, with the use of a simple serial (RS-232 or 485) signal converter to USB into a configurable port in your laptop will open a world of options. Upon boot-up, hold the SHIFT and F12 key down to enter your computer BIOS. After which you select the relevant baud rate for the port you've plugged your converter cable into. Now, boot up your computer into Windows and open the Toyota software. A list of features found on your Tacoma will be populated into the subsequent list on the right hand view. Now, with proper documentation at your side, you only need to adjust the sensor values on your Tacoma to fit your specific needs. Make sure not to go out of range on those sensors though. Gremlins are a real threat to the overall health of your vehicle. A good warm up to understand the proper lingo and semantics can be found in the following Youtube video:

https://www.youtube.com/watch?v=RXJKdh1KZ0w

 

Doubtful.

 

Took my sliders off, guna replace them with steps after they sell. In the phx area

 

finished up the air system on the rolling top of the ARB Drawer system....

 

So at what sequence in the electromagduction phase do I add voltage to the flux capacitor?

 

You have to be sure the duodonkulator valves have all been closed and the electromagduction complete indicator light has lit green before applying any voltage to the FC.

 

Got the tekonsha P3 brake controller installed last night in preparation for the new trailer brakes I just bought. During the install I also found the issue with my locker switch so I went ahead and fixed that too. Locker and brake controller ready for action!!

 

Tacomabeast Headlights.
Easy install, great light pattern 10/10 would recommend.

 

Threw a tape measure across one of my Wildpeakes and found out why I thought they looked smaller than I had thought they would. It's because they are. 265/75/16, but they only measure about 31".

 

Did you change out the steering controls yourself? Curious what size LEDs they are. I know they are smaller than even the typical PLCC2 that most other items take.

 

You might be one of the only people recommending anything from them right now

 

Late 2nd gens it doesn't work. I tried it. I think I read somewhere you have to take it to a dealer to disable but they won't for safety reasons.

 

Just talked with goose-gear fab and they are now(because of my pestering) selling their back seat delete in individual portions! I recently ordered a MOLLE panel through a group buy and wanted the bottom portion from goose-gear to go with now all made possible! check em out!

https://www.goose-gear.com/collecti...nd-and-3rd-generations?variant=21762216198249

 

Some will, just depends on the dealer.

 

Or get techstream.

 

Software is Techstream. Ebay 20 bucks comes with dongle.

Dave says for use only by white trash. Programs optional ejector seat.

@Mugshot89