What Have You Done To Your 3rd Gen Today?

Thanks for the input. The great thing with SnugTop the structure and paint have a lifetime guarantee (limited; goes without saying). The other benefit is the seal. No re-taping the bed rails if you need to remove it to haul your dirt bike, furniture etc.

 

I did keep them at the same perch setting. Unfortunately, I did not measure before I got them installed. I don't know how long it will sit like this. They will settle over time (all springs would) and I also plan on adding a bumper and winch so I know that will reduce it by a noticeable amount. If I was not going to add the bumper and winch, I would have gone down a perch setting for sure. From what I have read on here, the springs that come on the 6112's are 600#, the stock springs on our trucks are 700#. I am not sure why they put 600# on the 6112. I am sure there is someone on here that can shed more light into that than I can.

 

Wrapped the tailgate and mirrors. I think wrapping the mirrors black flows much better with the white.

 

what kind of wrap? satin blk? looks clean and matches well!

 

I keep a relatively small toolbox in my bed that slides every where without a mat

 

@KrnTaco08 daaannnnnngggggg, that looks amazing.

 

The mirrors are satin black.

 

Looks awesome, love the tailgate graphics!

 

Thank you!

 

Just picked up the rest of my King suspension components front and rear hydro bump and rear resi with cdcv valving, pulling all the Icon equipment next week! Also pulled the trigger on Dirtking Fabrication boxed stock length uppers and lowers. I’ll post more pix of the install

 

I was given a lot of shit for wanting this when I first saw them available, but ultimately I just wanted to have a flat surface back there while camping. I highly doubt I will ever use it as a cutting board and I went without the cup holders to save myself a few pennies(I know, ironic).

 

how and where did you tap into for the 3rd brake light thanks

 

That's all I got right now. Stock suspension, tires and wheel size

 

Added the Hornady vehicle safe. Not a bad vehicle gun safe.No drilling just a cable that can be bolted to the driver seat. More like a deterrent keeping the gun out of sight. It's well made and the RFID performs very well. I got a good deal on this product and wanted to try it out. I probably end up using the safe to store small valuables then my Springfield and maybe move it over to the passenger side. The gun usually doesn't leave my side when I'm out and about. @Hornady

 

Added some raptor lights to the setup! Used these: https://www.amazon.com/gp/product/B07JGSJLTD/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1

 

Tinted windows 20% all the way around

 

Tapped into the drivers side brake light. Did a military splice.

 

Installed @mesojdm ECT shift knob and fixed some rattles in my lights using o-rings.

 

Got my shell installed and the sun was out.