3rd Gen White Tacomas - Post them up!

Poor man's Yota, here!
'17 SR 2.7 4x4 5MT w/ utility package. Right at 30k miles, awesome little truck.
Just a few simple mods, I dont plan to do too much more to it.

-Curt hitch receiver & wiring harness
-UWS black low-profile toolbox
-tint 15% front, 5% rear and eyebrow
-RokBlokz mudflaps (had to mount the front ones a little higher, there was a gap bc of no factory flares)
-air dam delete
-SR5 wheels
-Hankook Dynapro ATM 265/75/16
-WeatherTech mats
-Sportsman Camo Covers seat covers (mossy oak bottomland)
-LJ's Wood Shop shift knob
-22" Magnaflow muffler


[/QUOTE]

 

Thanks!
My suspension is stock so it’s probably just the angle of the picture but I did put the air dam on the front as well as the pro fogs.

 

What is the “lip” you have on the lower front bumper? I like that look.

 

That’s the front air dam that’s found on all trim levels other than OR/Pro. A lot of folks take theirs off but I added mine.

 

What is it’s function? I’m sure it would get in the way if you off road.

 

It’s supposed to increase gas mileage and decrease wind noise. I really don’t do much off roading and if I do it’s easily removed.

 

Thanks for the info!

 

Just picked up a super white pro and I’m noticing brown spots on the paint from the tire shine flinginging back. Any suggestions on how to get this stuff off? I tried a clay bar and it made no difference.

 

285's & 3" lift? I'm guessing

 

Went to Anza Borrego, had to get these shots while out there

 

Just put on my lift this Sunday stage 4 icon and trd wheels w/ BFG KO2 275/70/16

 

How do you like your set up so far?

 

I use mineral spirits just don't let it sit on there. after you get off the gunk wash the area and treat it with a spray detailer or wax it.

get a different tire shine too. I like chemical guys silk shine it doesn't sling. or if you like glossier their tire kicker shine is glossy but doesn't sling, works great on the black plastic too on the tailgate and overfenders.

 

Personally I like it but I will say since the icons are stiff the ride is a little bumpy but doesn't bother me at all. I also left the front coilovers set they came preloaded from the factory and it sits perfect!

 

Yes I have everything done, I believe, in my sig.....I should add the LED lights I just installed but I have already been flamed for that on another thread ...not that I care was just sharing info and helping out another guy like me looking for what I wanted

 

Thanks bro for the response, was leaning towards that wheel / tire / lift combo for some time now. When you first got it lifted were you rubbing anywhere near the cab mounts? Thanks in advance.

 

I was rubbing on the fender flare where it meets the black plastic on both sides when turning....had the dealer adjust the castor, i think it is, and also adjust my lift up as it was not the full 3 inches but probably close to 2. No regrets on lift....it rides very very well and not uncomfortable at all. Hard to compare to factory since I only test drove a truck once months ago but it is not stiff and ride great. I am still trying to find some mudguards though that fit....may have to go universal flaps and drill out mounting holes possibly but I would rather find something from the get go that works already.