TRD/ Magnuson 4.0 Supercharger Tips, Tricks, and Mods

I picked up the kit with the spray gun on Amazon but didn't have time to apply if before winter I did wash the truck religiously though after the few times I used it. Will be doing some serious frame cleaning before I apply it next fall. Will be my first application.

 

My kit was installed at a shop but I'm not certain of my trans fluid level. The correct check method is a PITA. I'll pay the dealer 60 bucks to do it right.

 

You will be impressed.

 

I have a new in box Ratiotek kit if anyone needs one.

 

I’m interested. I can’t really justify the Cruiser Brother Kit over the ratiotek.

I will have a 2.8 stealth pulley up for grabs here shortly when my quick change arrives.

 

Sucks when you lose track of your balls. Just saying.

 

I'll take it!!

 

Yeah but those bearings also endured 2.7 and NST for around 25k too now that I think about it.

 

Anyone know if adding an oil cooler would affect the oil pressure?

Thanks

 

I have the nst crank pulley and the belt out(like totally shredded) in about 3000miles

 

Shredded cuz of the pulley?

 

What? This seems like a waaaayyyyyyyy to short of a life for a pulley and a belt.... unless you are driving through sand storms and razor blades...

 

It happen twice and I change the main pulley back to original and trouble free since then

 

Did you tell NST? Did they have anything to say about it?

 

Does anyone know the product numbers for our sc idler pulleys?

 

Found it last night on here somewhere. Smooth idler bearing #6203, grooved pulley bearing is 6303-2rs

 

Is anyone running with the restrictor jet removed? I saw it's still listed on the first page as a mod, but I could have sworn I read somewhere in this thread that some were experiencing a lean condition with sudden throttle application (tip in?) but I can't seem to find those posts again.

 

Depends on how small of a pulley you run. Opinions vary on this topic. Mines out. But I may put it back in some day. It doesnt decrease boost as I understand. Just apply it a little smoother.

 

Yeah I want the whole pulley though and bearings included for backups.

 

Same here. My reason for searching. Maybe dealer for official confirmation then to rock auto for purchase?