Pelican/Plano Mount on PrInSu Rack

i just realized im mounting mine in a bajarack basket and wont have the room to slide it front or back to remove it. but looks like there is straight up and down mounting options..either way im going to look in person.
great idea bud
https://www.trollingmotors.net/collections/quick-release-bracket

 

This looks like a winner, hopefully someone can get one or at least see one in person to give us some insight! I am looking forward to this, definitely a cheap option and looks like a very secure one at that.

 

So, went to cabelas and did a thing.

Install was easy, only one modification was made. I had to add a 1/2 inch spacer to the bottom of the zarges box to allow the slide to clear. Mounted directly to drop in t nuts and made my life easy. A quick trip to ace hardware to pick up new length bolts to match, and it was finished.

There will be a second box mounted on the driver side

 

Getting it done on nightshift

 

yea buddy looks siick

 

Awesome glad it worked. How easy is it to take of and off?

 

Extremely. Only challenge is getting to the small knob that tightens it all down and locks the box into place. Still easy to do though

 

you have to slide the whole box forward until it gets out of the bracket, correct?

So that's 14" forward or backwards that you need clear?

 

correct. Since I mounted mine towards the front of the rack, I slide it out towards the windshield

 

Cool mount!

 

What is the name of that mount?

 

Here I even provided a link that you also overlooked.

 

Thanks, searching for mounts brought me to page 2. Didn’t realize you discussed it in page one the Website you referenced a different store in page two....

 

If you have two short mounts, you could mount it in a way that allows you to slide toward the drivers door, or passenger door. This would be quicker and easier to remove, I believe. This would be 90 degrees from what’s being shown in the photos.

I say two short mounts... one towards the front and then one towards the rear of the case. I suppose one mount may suffice.

 

Replacing the bolts with these might help.
https://www.losspreventionfasteners.com/store/products/t-groove-tamper-proof-bolts/
You can also get nuts from here if you need some.
https://www.albanycountyfasteners.com/Metric-Zamak-5-Zinc-Alloy-Tri-Groove-Nuts-p/6206-024.htm

 

Anyone use recently install an Eo2 setup recently? Trying to figure out the best method to attach the plate to the rails.

 

So my plan was to buy:

1. Pair of Prinsu load panels
2. Long EO2 bottom rail (per side)
3. SnapTop EO2 top rail with lock (per side)
4. Necessary Pelican cases
5. Security bolts to replace Prinsu crossbar bolts (I've had good success after swapping my ditch light bolts for these)
   
6. Custom all weather decals from same company I ordered my door flags that say “CASE CONTAINS NO WEAPONS”

 

thanks for the response! I’m leaving for a trip next Friday and unfortunately won’t be able to get the load panels on time. Pelican case and eo2 fasteners are arriving Tuesday. I’m trying to figure out the best possible way to attach the bottom panel to the rails. Looks like I may have to drill holes through the bottom plate rails and attach with t nuts.

 

Damn they stole the crossbars too ?!?! Holy

 

I know this is an older post but what was the company name you ordered that sticker from. Thanks!