GraveYard Shift BS

Better have some beer

 

I’m on number 2. About ready for bed. I’m wore out from being out in the sun all day.

 

Oh here’s today’s catch. 6 whiting and one Pompano. Didn’t keep the sharks but we caught 2 bonnet heads.

Pompano was 13” to the fork for reference.

 

Cool

 

WTFand ouch is right! Good luck.

 

Just checking in. Hope y’all are well.

The puppy is freakin exhausted from her adventures.

Also... I will be visiting a muffler shop to get that exhaust reroute everyone is talking about... NOT because I was busy talking on the ham radio and not paying attention to my line. Obviously there are no pictures of my squished exhaust because it didn’t happen. Lol.

 

This is yuck, dude.

 

That looks so painful

 

Good Morning

 

Morning Maner

 

Morning Murph
How is the feets this morning

 

Dude, it comes pre-squished from the factory.

 

Id grab some stainless MIG wire. It'd also be best to grab a bottle of trimix to weld it with. Would be a better option than buying a whole new machine unless you wanted to.

 

Ok thanks. I will look into the wire for my small 180 machine and compare. I only tig stuff like this.

 

I popped the blisters so I could get my feet in my tennis shoes. Lol

Still hurt but I’ll manage.

 

Haha that's a long seam to tig!

 

Just a two beer run.

 

But, does it come pre-scratched?

 

Haha right. I Mean as the old school rule of thumb you need an Amp for every thousandths of an inch, less %20 or so because it is stainless. I'd probably go at it with 110 or so and move quick.


Basically at that amperage you could just set up a stick welding machine for tig welding too. Just run scratch start

 

My big thing is low heat for warpage. I can haul azz with a wire set up and will give it a try on some scrap. All the welds get polished to look like square seams anyway.