What Have You Done To Your 2nd Gen Tacoma Today?

Thanks, man. Really happy how they turned out. Now to just do some cutting to make em fit.

 

Did a rear diff breather relocation mod so the check valve is behind my rear tail light. Drained and filled the rear diff with Lucas 75w90 synthetic, new crush washers. It was dark and milky, apparently a little water egress happened recently.

 

Been considering that grill. Is the fitmant as nice and flush as it looks? How are the Raptor lights wired in and are wiring instructions included?

Thanks

 

Did a front/rear dif fluid change, oil change and added the Fumoto valve.

 

Good shooting', Tex. Better than paint and bodywork. You hit the cheapest part.

 

I watched up to 3:17 where the mech makes an easy mistake with his "math." The difference between the prop shaft and pinion degrees is NOT (2.8-1.9=1.0) as he states. Putting the angles in + & - since one is "right" of zero and the other "left" of zero give a difference in angle between the two of 4.7 degrees. Anyone else catch this?

 

I read this post up until I realized there were two of the exact same posts. Anyone else catch this?

 

I'm not a huge fan of Chick-Fil-A but this is a great 3D print

https://www.youtube.com/watch?time_continue=315&v=55ROTsNxUzA

 

Had a shop install my pinion shims reversed. That was a great demo of the "working angle." Noticed it as soon as I picked the truck up by doing a walk around before driving out. The test drive didn't notice any vibes, so it would've been a good deal of unnecessary wear and tear on the u joints until failure.

 

Mmmmmmm, chicken...

 

Fuck, that’s awesome. If I had a third gen I’d be all over that

 

You’re wrong their delicious nuggets don’t need to be dipped in sauce

 

I believe he also showed a round cupholder version

 

Woah woah woah. You’re talking to a literal CFA VIP here. I’m more of a strip guy, but they absolutely benefit from some CFA sauce on there.

 

I didn’t make it that far into the vid. I’ll habe to check it out.

 

@mesojdm designs and fabs these bad boys. Check out his webpage and thread https://mesocustoms.com/collections/toyota-tacoma-2nd-gen-parts. he is a busy dude and fills orders as soon as he can...then poof they are gone so you’d better be quick! I have a similar one coming in the mail from OG fab if you’re interested send me a pm. I bought the meso one when I saw he had in stock just because I like his products.

 

Do a comparison for me

 

I need this in my life!! It needs a cover latch though because the Chick-fil-a sauce is so thick the nugget wants to lift the sauce container! hahahaha

 

This isn't your facebook. Its what have you done to your Gen 2.