‘18 OR 265/70/17 on Ray10s

Do you have more pic of your Tacoma?

 

Top photo is before lift.

 

I have more I can send you but they are on my computer.

 

I think I’m going to order just front suspension like you did

 

I did it because I wanted to keep the ride as factory as possible. I was also worried about having to go with the ecgs bushing if I went higher. Plus I’m going for the clean street look but capable off-road.

 

Tire poke with the ray10’s

 

How many inches of lift did you get in total in the front?

 

What size tires

 

265/70/17

 

What size Ray10 do you have? I have the 17X9 with the 3.5bs. I want to know what I need to do to run a 265 70 17 without rubbing. I would like to stay away from the cab chop and the seam weld bashing.

 

The ray10’s have a -10 offset which makes them stick out. With that size tire and stock height you will definitely have to remove the mud flaps and front air dam if you have a sport. Probably have to heat a little plastic and mold it some. I lifted an inch and still rub in reverse full lock.

 

Mine are 17x9 -38 offset.

 

Well then you got the deep dish. If you plan on running stock height that’s a problem. No way that’s working.

 

In that offset and width you’ll need to do a cmc and some trimming

 

Heat gun and a bbq glove t push the plastic. I had the same issue with the same wheel/tire setup and 5 minutes with my heat gun fixed that. Can't tell by looking at it and didn't cut anything off. Most likely you are rubbing on the little piece of hard plastic that has a little extra tab on it that sticks out. Heat it and mold it.

 

I dunno if im willing to do cmc. I figured a 5100 lift may get me there.