Norcal Spotted and BS Thread

So you've got lockers... where are you buying from?

 

Also, yes I think ours is the same. You have to trim.

 

Sweet! Thanks man.

 

Yup! A local shop in Auburn is doing it next week.

I ended up ordering a 6-switch panel for one of the sunglass holders on the headliner. I just hope the locker comes in tomorrow so I can wire the switches for it and the compressor before next week.

 

Cupertino Electric...

 

Good eye!

 

Just got the email that my BAMF sliders are ready!!

 

That’s a good email to get.

 

Anyone have a smittybuilt rtt? Looking to get a tent but not going to use it enough to make it worth spending tepui money. Just wondering how the quality is.

 

@cbechtold my welds are starting to fail on my swingout so I pulled it off to mend and edit/repair it. What changes are you making? Maybe I can steal some ideas since I'll be at it

 

The goods

 

Yea dood!!

 

I'd probably just build something similar to what the guys at RelentlessFab offer, minus the latch they use. I'd use a Synergy latch I currently have. This I love mine! Not much else would be different. Jerry can/Rotopax mount, fold down table, tire carrier. I'm going to wait to rebuild it until after I put a ARB in my front diff and 35s on the truck. Maybe this upcoming Winter, if not Spring.

 

Thanks @Anderson for the SLUT Leaf pack. My cousin and I will be sure to clean them thangs up.

 

Do your switches by chance dim with your dash rheostat? I know that our trucks have variable voltage on the negative circuit, so it's tricky. I was going to try a few things, but figured maybe someone here would chime in first.

Ready? Set, GO!

 

Mine did not. But I wired them straight from the battery and didn't bother with the dimming circuit.

 

Keep going. I’m almost there.

 

On the black HVAC connector, tap the solid green wire (+) and connect to the positive illumination wire from your switch.
On the black HVAC connector, tap the green wire with white trace (-) and connect to the negative illumination wire from your switch.

 

Mmmmmm the fold down table. I need to do that for sure

I was debating 35s too once these wear out. But @Fernando here is constantly having issues lol what are you gonna do for your wheel bearings, CV'S, and gear ratio? I'm short on funds so I'm nerding out on everyone's toy success but am thinking 4.88 and arb front. Already have the compressor just need to install it. Oh and lights. I need lights and time to wheel.