San Antonio

Well no cause I want a softtoper just don't want to pay 850 for a brand new one

 

Thank them for giving you good questions for your research!

 

Im fairly sure the only difference is the little aluminum round bar that goes in the rear window. Definitely give them a call, but that one should work for your truck!

 

It didnt specify heat and bend but i dont see how else it would bend. I beat the hell out of it with a 5lb sledge and it didnt budge

 

Then you get a bigger hammer lol

 

Bigger hammer wont fit lol tight space down there

 

when I did concrete work I use to swing 40 lb sledge hammers at stakes that was back when I was 17 not anymore

 

One of our friends that welds would know for sure, but I bet you could heat up with a torch with a couple vice grips on , and WITH REALLY GOOD GLOVES, bend that sucker. Let it cool down, remove!

 

You was a different kind of mule back then

 

Try a air impact chisle

 

I did nothing but maunal labor from 16 to 28 my back payed for it now I'm 60 or at least I move like one lol

 

Ive been contemplating just cutting it off haha

 

nah, you went this far, finish it off "close to" right!

 

That

 

I swear if it rains next weekend and cnc gets cancelled I'm going mudding at HF in the pouring rain

 

Night oldie

 

Most muffler shops have them in stock

 

Good Morning Everyone

 

Less than an hour to go.......I need sleep

Morning Maner,