What have you done to your Tacoma today? 1st Gen Edition

What’s your front set up?

 

I bet you could find a window switch at a pick and pull or tear apart nearby where you live. If not, then maybe rockauto?

 

Hoping these fixes my creaky noises when turning slowly, probably won’t get to put them in until Friday or Saturday.

 

Are you boosted? I have an AFR gauge and it'll read as rich as low 11s under WOT and heavy boost/load.

 

Creaky noises when turning slowly? That would almost certainly be uniballs and not spherical bearings on the shocks.

 

Guarantee torque wrenches are used everyday to remove bolts... ask me how I know.

 

I did this.....

 

You should be shooting for 11.5-11.7afr with your turbo setup at wot

 

Fox 2.0’s and Total Chaos UCA’s

 

Or just take apart your switch and clean the contacts. I've done this many a time with other vehicles over the years.

 

Oh I get that. I've done it myself, recently- because I didn't feel like digging to the bottom of my truck box to get the breaker.

I have GOT to do something about organization.

 

Diff carrier bearing replacement? Does this require a full setup of lash and everything on this sort of axle?

 

This is the type of DIY I fucking love to see.

 

x2

 

I forgot he was turboed...in that case @Reh5108 you should not be relying on the AFRs your ECU is reading, you should get a wideband AFR gauge installed that reads off of an aftermarket O2 sensor welded in just before the cats. Using the Torque app to monitor your AFR the ECU reads under boost is not an accurate way to read them.

My torque app will read AFRs in the low 13s but my Wideband gauge will read low 11s at WOT and ~6psi

 

This weekend I installed TC cam tab gussets and Solo lower control arms. Was a hell of a project. Turned out great though.

 

You'll be real close to the correct settings if you put everything back to it's same settings. Mine was right on after pinion and side bearing replacement. Put I small pin punch mark on the side carrier bearing adjusting nuts helps.

 

Finally, we found it!

We took it all in. We enjoyed every minute. It had been a true Indiana Jones style adventure - one where we'd known what we were looking for, but not where to find it. One of those rare places that the Internet alluded to but never actually divulged the exact location. And in the end, I think that's what makes it so special...

And we captured it all in Anza-Borrego Part 6 - Finding Blue Sun Cave​

​

​

Anza-Borrego Part 6 - Finding Blue Sun Cave
​

catch up on the entire story here:
Double Fun @ Anza Borrego - March 2019​

 

Thank you sir. I am about to do R&P on my D44 for the SAS S10, so thought I'd get an idea how this one will compare. I will eventually be SASing the Tacoma, still haven't determined if I will stick with the Toyota rear axle or go with a D44. I already have a set of D44s available (sitting in my back yard) and am a big fan of using "standard" parts (that is to say, same axles across my builds).

I need to learn more about the Toyota axles, first, before I make my decision. If the Toyota axle is demonstrably stronger than the D44, yes, it will stay- especially since the lug patterns already match.

 

Thanks for this. I always love your posts, not the least for the photography.