What Have You Done To Your 3rd Gen Today?

Anyone know a part number or a source for the under hood fuse panel lid?

 

Gives me something to look forward to.

 

Switch out the olives for some jalapenos!

 

Catback... everything from the cat, back. That's a catback in the box. Unless I'm misunderstanding your post.

 

Did away with the bedsides for a CBI high clearance rear bumper

 

Dipped the grill and installed step rails.

 

Put on a red LED strip as a 4th brake light on the weekend. It's positioned low to be at eye level of pesky Civic drivers. I added a blinker module as well. Since I don't tow, I tapped into the trailer connector.





LED strip:

$11 EverBrightt 2-Pack Red + Yellow 3528 + 3014 48SMD LED Motorcycle Light Strip for Taillight Brake Light Turn Signal Lamp DC 12V

https://www.amazon.com/gp/product/B01ITBTSHC/
Blinker module:

Flash Strobe Controller,EFORCAR Flasher Module for LED Brake Light Tail Stop Light Auto Car 12-24V LED Brake Flasher Stop Light Lamp Flash Strobe Flasher

https://www.amazon.com/gp/product/B00T2P1TWC/

 

I installed this soft touch controller instead of using rockers. Just need to label the buttons still.

 

My switches are not rocker, they are push switch. Good thing about yours is the option that you can hook more stuff. I still have one more in the bottom at original blank spot and if I need to add something in the future I can use that.

 

@CXYyuppie lol no i dont think I'd want to eat any of what is left over...there were pieces parts left on the highway

 

@87Taco18 sorry but I'm not selling anything off of it. The damage looks to be confined to the front and front driver's side. The driver's side rear door didn't get touched.

 

Oh well, it was worth a shot. Nothing like fresh venison. I hope your truck is repaired quickly. Good luck.

 

Thanks, at 1st glance body guy estimated 10 to 14 days or so.

 

Installed a Pro Skid and some of MattGecko’s bed lights tonight. Took a while, but ran ground back to the battery with the positive cable instead of putting a hole in my frame for chassis ground.

 

Does it really deflect bugs?

 

Hopefully not to much to ask but can you show a close up of the shock mounting points and also a pic of the hood partially closed to see where it is going to rest when the hood is closed?
This is what I'm needing to know. Will it clear my fuse block mounting point(I utilized the same holes as a clutch slave mounting bracket)

 

The soft touch controller I installed connects with a VGA cable to a 6x relay module I installed in a project box under the hood.

 

The 6x relay box is the black unit. The blue relays are Wifi triggered!!! Tested tonight at about 50' with the hood closed. Gotta love Amazon for cool stuff.

 

It’s what would be considered a catback. It’s basically a mid pipe, muffler, tail pipe and tip all in one. It bolts on right after the two exhaust banks converge into one. And no it doesn’t come with a gasket or hardware. You reuse the isolators and the bolts. Since my truck only has 650 miles on it I reused the gasket but you may want to get a new one if your truck has more miles on it.

 

I installed it today and I love the sound. I wanted something quiet but with a little more tone when you romp on it. It’s just loud enough to be satisfying without being annoying. But man does it look good tho....