4Runner TRD Pro Wheels

265/70 R70
Just put them on, no rubbing anywhere yet (haven't been off-road with them yet) but I'm going to be lifting a couple inches soon just to have more breathing room.

 

I went with Wildpeaks 245/75-17. I had planned to use wheel spacers on stock OR wheels, the extra offset on these wheels is perfect. I have no plans to add lift or remove mud flaps and I couldn't be happier with the results.

 

I personally love the gloss (hence why I got them) matte does nothing for me but each their own

 

Looks great ! Any pics from the front ? I’m thinking about going 255/75/17

 

I did not like the stock look so ordered a set of 4Runner TRD Pro wheels with Nitto Terra Graplers(265/70/17SL). After a week of not hearing anything from my salesman, I went over there to check on them. The parts department didn’t order them. I was not happy and with a discussion with the manager, they pulled a set of a new 4Runner TRD Pro in the lot. They had to do the TPS swap. They did not charge me but it was probably b/c of their screw up. I am happy with the end result, but I wish there was something in between the gloss and matte finishes. Maybe a satin. The matte is a little more difficult to keep clean.
Before and after

 

Thanks, I like that the outside of the tread is even with the mudflaps.

 

tire size?

 

265/70 toyo at2 SL

 

Any rub anywhere? How inaccurate is the speed?

 

265/70/17. No rub at all

 

No rubbing at all. I raised the front and rear with 5100s. The speedo is dead accurate with me gps. More accurate than the stock 265/65s.

 

exact same setup 265/70/17
Zero rub
They do stick out 0.5” further than the stock OR wheels though. Borderline with the fender flares

 

265/70’s on KO2. Minor rub, think on the mudflaps. Stock suspenny

 

His are the same size as mine and I am 1.1 mph faster than the speedo and I do not rub any where. There is a thread with different tire sizes and when you need a lift and what size. I think it’s called Wheel and tire size; will it fit.

 

I am a little slow when it comes to wheel offset. From what I can tell the trd pro 4runner wheels will stick out sightly over an inch from the sport wheels on my 2019 Tacoma. Is that right? While I'm at it, so far I have conflicting reports about the tpms sensors being there same. Can I just take them off my stock wheels for the pro?

 

They will protrude a little more than with the stock rims. How much really depends on the tire width. I have 265's and they appear to be about flush with the fenders, or just slightly beyond. TPMS sensors from stock alloys will fit the Pro wheels with no issues.

 

The TRD SEMA 17" 4 runner Pro wheels stick out about 1/2" beyond the standard TRD Off-road wheel. I am assuming the Sport wheels are similar in off-set to the Off-road wheels. They are the same width.

 

The specs I found said offset of 30mm for stock sport wheels and 4mm for the 17" pro wheels. If I understand offset (which I don't) that would be about 1inch more poke or 26mm. That picture helps. I have 1.25 spacers right now and I really like the look. Doesn't look like it will change much with the new wheels

 

285/70/17