SOLD

$50 shipped

FS after market bumper frame reinforcement plates. 3/16 plate steel and bolt right up. Bought these from @At The Helm and ended up not needing them. Painted them with bedliner. Just looking to get back what I paid and passing them along.



Picture of how they mount and possible interference with remote reservoir mounts:

 

Hmmmmmmm

 

You want some dis?

 

My King resi are where the hole is on the frame where they mount

 

You could notch the resin mount. I actually installed something similar with a relentless stingray and we just drilled through the mount so it acted like a giant washer.

 

where do these even bolt onto? side of front frame rails?

 

Theres a hole in the frame next to/behind where the side of the radiator is, when looking at the front of the wheel well. Im not sure if that is a good description..

 

I think i know where you are talking if its the same spots king resis mount to. Still gotta get the motivation to redo my bumpers paint job and reinforce my front tabs for a winch.

 

Its behind where the resi mounts to

 

Here’s a picture of them installed (not my pic) but they attach to the bolts for your bumper (or crash bar) and tie into a secondary hole in the frame behind the radiator mount.



For reference the above picture also shows the interference with King reservoir mounts and the rear mounting bolt.

 

cut a section in the middle of the mount out, that's what i did

 

Do these work with any bumper? ..ARB?

 

Dunno. I suppose if the mounting bolts and frame are exposed they would work. They are designed for “traditional” plate bumpers (ATH, Pelfrey, SOS, Brute Force, etc).

 

Hang on I'll snap a picture

 

For those with an ARB bumper

 

I might need this. My rest mounts don't work with Billys. Ill have to double check tomorrow

 

Lemme know.

 

bump

 

Forgot to take my truck to work today. Ill check when I get home. Going to be chopping off the rear shock mounts today.


Bump

 

So you want them or are you bumping my thread?

#mixedsignals