What Have You Done To Your 2nd Gen Tacoma Today?

Used a sud gun to apply but manual labor.

 

3d printed a Batman to replace the Toyota emblem. I'll Plasti dip it. Not sure how to attach it yet. Any suggestions?

 

Couple dabs of silicone maybe

 

Dat is the goop that comes out of the PVC line seperator, the other picture in the original series...its also what goes back to ur intake without the seperator..There is way less water (as in none) without the seperator as in the winter it allows the warm flow thru it to condense ...but it does push all the other vapor back to the intake....I drain mine into a baggie as its the easiest thing to fit under the drain line

 

Not sure I will do much more to my truck. Been thinking on selling it and getting a 14 or 15, not sure what all the negs are on the 16's and up. Hate losing all my mods, Lift, Tires / Wheels and Gear swap, but won't miss thye lost gas mileage . Still contemplating . Nothing wrong with mine, 137K miles just had it so long ready for a change I think. ( Might Be Sorry )

 

I have a '15 I don't honestly think you will see much if any difference in mileage

 

Just change the paint... then you'll think you have a new truck!

 

Depending on what material you used, any glue you use will eventually fail and you will loose the part. Next time add bosses to the back side of the design file so you can drill & tap them, then bolt it to the grill.

 

I cut so much out from behind the stereo area that there was more than enough room to leave the whole clock/hazzard assembly plugged in and just lay it back behind there for now. I can't tell you for certain that i've even used my flashers once in the past 10 yrs, so relocating it is low on the priority list right now

 

That looks like the perfect ride height, very nice.

 

That's quite the run!

 

you might not have, but has the inspection station? might have issues getting a sticker but IDK about Washington

 

I used PLA for the first prototype. Its only a 3 hr print. I will reprint with PETG.

 

No vehicle inspections in WA

 

well then i guess you're all set! please disregard.

 

What bout inspections?

Nm... same w/ md as long as title doesn't transfer to someone else that is.

 

No inspections required here on sale/title-transfer even.

 

Picked up a new bike. It’s a cyclocross/commuter/gravel/adventure/BS/dad bike suited for literally everything. Will be putting some bigger tires on it and setting it up tubeless. Normally $1000 I grabbed it for $450.

 

Changed my serpentine belt. Bit of a pita, but not as bad as I thought. Getting an allen wrench in the hole to hold the tensioner slack was a joy. Routing was a little bizarre, but about 6 looks from the bottom and the top working half blind, I finally got it.

 

Washed all the bugs off the front and installed a new cabin filter !