Ontario BS Thread

Hobby, or full-time procurement job?

 

The quality on those AP brake lines are so nice.

 

On pavement its called hooning

 

I have a question for my fellow cunts. When I did my spring swap I use the lower control arm to compress the spring. I noticed on the one side the lower control arm was not loose but moved very freely with a little bit of spring back towards the upper control arm. Is this because of my Moog greasable cam bolts or is there something amiss?

 

Thats next on mine

 

Would be nice if both front brake lines were the same length Same P/N on the bag, but slightly different construction. The shorter one with the Crown label is also lacking the Teflon jacket over the steel braid.

 

Yea I noticed that in your pic, mine showed up with 2 exactly the same



I got 2 of the Teflon jacket ones with nice rubber ends before the connectotion.

 

Judging by the labeling, I think the shorter one was made under All-Pro mgmt while the longer one was under Trail Gear.

 

The shorter line is 13" while the longer line is 16.7" as advertised. Even the shorter line is still longer than the ones Wheelers sells (11.5").

 

Did you use the bushings and the whole kit from moog?

Remember reading that the bushing failed prematurely and there would be movement after 10-20k. I ended up going oem which sucked....but my original ones lasted almost 200k and the only reason I switched was because of the cam gusseting.

 

I bought new doorman when I did the cam bolts. Bushings seem ok but I haven't fully inspected them.
What's a normal amount/type of movement expected from a lca not connected to the spindle?

 

I also have a drastic lean to driver side... Measured at around 3/4" difference. I did slide into a ditch at 80km/h this past winter. How would I check if I bent my spindle?

 

Rear break lines for me, i didnt look that close at the picture haha

 

its possible. I think a bad alignment. Possibly measuring some distances from certain points.

 

The north is expensive...
Terrace Bay

 

Yea, it has been over $1.20 in North Bay for weeks.

2 months go it was $0.85 for over a week.

Its all very 'TAKE THEIR MONEY!@!!!'

 

holy hell and i thought $1.15 was a lot at costco...

 

Probably profit-taking at each step of the supply chain while using the carbon tax as the scapegoat.

 

I got those too, to be safe with the extra-droopy Icon RXT setup.