Colorado B.S. Thread

https://www.tacomaworld.com/threads...ttery-system-q-a.468553/page-27#post-20326612

Rumor on the forum is that off-grid engineering is discontinuing their side by side dual battery kits after making one last batch in June. I just ordered one...if you like this kit you should too.

 

But that’s a lot of weight on one side...

 

It is, but my preference is for shorter wires and everything in one spot.

 

Sounds like a good way to expedite core support/inner fender destruction.

 

You will have to remove a battery to get to oil filter to change it too. Not a biggie but something to know.

 

Sounds like typical German engineering that people pay extra for.

 

I did not know that...good to know. I've also heard its easier to remove the headlight assembly to swap bulbs, but in order to do that you need to remove a screw near the fender before the dual batts go in.

 

3.025 Tons of Fun

 

Some people measure in inches and feet.

Others in crocs.

I give it one and a half crocs.

 

I just picked one up from Bud's and sent to an FFL dealer located at University/Quebec in H.Ranch and the xfer fee was $35. Good dude, I plan to use him again in the future.

 

Did that mod to the wife's CR-V a few weeks ago...fun mod

 

Looks like Grinchsquatch spotting

 

Thanks I'll check with eccracer104 on here then.

 

I'm lucky I haven't been popped yet. Changed oil twice - once in the street, once in my designated open-air, uncovered parking spot. Swapped wheels a few weekends ago in the street. I think the high school kid across the street dropping the engine in his shitty miata will (should) get popped before I do.

 

Snow day Tuesday!

 

cute but I'm ready for the snow to go.

 

Uhhmmm..... Tillamook small batch Salted Carmel Toffee Gelato

NOW!

 

Are these things typically expensive?

https://www.tacomaworld.com/threads/gearwrench-lot-for-sale.604163/#post-20495603

 

Same set is $100 at Home Depot.