What Have You Done To Your 3rd Gen Today?

New @CaliRaisedLed fog light. Great quality. Easy installation

 

Ditto! I love mine.

 

Mounted the relentless fab quickfist mounts for this weekend's camping trip.

 

Get gap insurance next time, it's a peace of mind.

 

Do you know the size bolts needed?

It looks like it would interfere with the hood struts though

 

Hey guys, curious if anyone has noticed a gap on the stock air box lid. You can see in my first pic a little bit of red from trd filter that fits the stock air box. The two other pics are my air box with the factory filter in and I also asked my dad to send me a picture of his (also stock). I did have a good look and it seems to be sealed, but I really wanna make sure. Thanks in advance

 

6 months in and just turned over 2,000 miles.

 

Congrats on the milestone, you gonna change your oil?

 

Never really noticed it until I pulled the air box to modify it for the snorkel, likely the tabs not seated right from dealership filter checks. Sits good now

 

Are those tacomabeast lights?

 

Finally installed my Relentless Fabrication bed rack. Really liking the design so far. Still need to install the side rails for mounting accessories, but that can wait.

It’s going to be really close getting into the garage once the RTT is on there.

 

Did you plasti dip them?

 

Ok, mines completely locked in, zero wiggle and it’s right where it needs to be it was just then 3/16”-1/4” gap I was worried about

 

Look what showed up from Demello Offroad! I will be getting busy putting his Hybrid Sliders and Alum Low Profile Baja Bumper on today!

I will post some pics of the process. So pumped!

 

where did you find this?

 

I'm really not sure what the bolt sizes are since they were provided. Are you talking about interfering with the redline mod?

Thanks!

 

Warsteiner FTW!

 

I have a question I have a boring sr with a 2” leveling kit and I want to get at least some wheels to it and the wheels I found are 17x8.5 4.30" BS 6x139.7 what’s the best tire size I could get to where my wheels poke out a little and kinda give it a mean look

 

With 2" leveling you can potentially run 285s but there might be some trimming involved. Usually with a suspension lift you have the option to adjust camber/caster to fit well but I am not sure with leveling lifts. Otherwise you can always run wheel spacers to get the poke you desire with the understanding that wheel spacers can be sketchy. 4.30" BS is almost centerline on that wheel unless I am mistaken.

 

Looking good I must say.