Will 17" Sequoia Rims w/15mm offset work...

Thanks for the pic, they look nice. Do you have a pic showing the whole truck?
Thanks

 

Will these same rims fit a 1st gen too? Bolt pattern and offset is the same as the 16 inch stock ones, but not sure about the backspacing.

 

Those look pretty nice! I bet if you painted them black it would look a lot better.

 

In regards to the 1st gen question...

the wheels will fit, but will require spacers for proper clearance

 

Why is that? I figured because the width and offset were the same, there would be no problem.

 

um, no they're 17x7.5 with a +15 offset, it would need to be a lower offset to compensate for the wider rim.

 

Your wheels look great.....what size tires are you using?

 

Those look sick bro!!!!!

 

265/70/17 on stock ride height. I'm also considering getting them PC Bronze.

 

Would these work with a 285/70 tire? I don't want to use spacers

 

With that +15 offset, I say no. 285 width tires will rub on the upper control arm.

You want a 0 or -6 offset wheel to run 285 width tires.

 

You could actually get away with a +6mm offset. That's 4.5" backspacing for 7.5" wide wheel.

But either way, Steve is right, you would need wheel spacers in this case.

 

I'm going to dig this thread out and ask; Will a 295/70 be too wide for this rim and if not, will I need spacers?
Running UCAs.

 

you would definitely need spacers.

As far as the tires fitting the rims, check on the tire manufacturers website. Under the "specs" they list what rims sizes each tire size is approved for.

 

Thanks guys! With the price of the rims, powdercoat, and spacers; it looks like I'm better off ordering aftermarkets.