What Have You Done To Your 2nd Gen Tacoma Today?

Hell yeah!!!! Who says you cant, CVs are replaceable.

 

Link??

 

Your making sure to keep the blocks in the back right?

 

It's not a kit or anything, just a few stainless steel/aluminum crimps, turn buckles and wire.

 

It’d make a great video

 

I agree. Click here for limb riser video.

 

Alternator went out after successful ECGS bushing / seal replacement SOOOO?!
Replaced Alternator, finally failed at 192,375 so I AFAIK it served a good life

still chasing that 29-33mph shudder... looking like its gonna be driveshaft alignment or just toss it all for a Tom Woods DS.

 

Mine was the center u joint,

My shutter was the center u joint, replaced all 3 for about $80 and all was good from there for roughly another 120k miles and still counting

 

Uni filter and fog lights!

 

Started prep work for tomorrow. Dropped the hitch and rear bumper. Wire brushed and sanded the steel on both in prep for rust prevention and new coat of paint. Then got it on on jack stands and spacers removed in prep for pads and rotor replacement tomorrow morning.
After pulling the hitch and bumper off I now understand cutting the fenders for a high clearance bumper. There is SO MUCH ROOM for activities under there and I am not even lifted.

 

New tie rod ends. Last bushing to over haul will be lower ball joint.

 

Where’d you get your third brake light?

 

High Mount Stop Lights Full Rear LED 3RD Third Red Brake Tail Light Replacement fit for 1995-2016 Toyota Tacoma Truck (Smoke)

High Mount Stop Lights Full Rear LED 3RD Third Red Brake Tail Light Replacement fit for 1995-2016 for Toyota Tacoma Truck (Smoke)

https://www.amazon.com/dp/B074V6SWXH/ref=cm_sw_r_cp_api_i_4rk6CbR69NN7C

 

Hacked apart a $30 Amazon charging phone mount and bolted a small part of the arm to the dash. Solid as a rock and not nearly as bulky and obtrusive with the huge mount and suction cup and crap. Love how simple it is to throw the phone in and that I get a little charge everywhere I go

 

Put new axle in place today, button up the brakes, etc in the morning

 

Alcans... Some of the best money I ever spent! You will love them bro!

 

4" one piece aluminum driveshaft was the only thing that fixed all my vibrations. Local shop, USA Driveline, does alot of them for Tacoma's. Out the door it was $850.

 

Installed my rear bumper tire rack today. Now I’m just waiting for the jerry can and high lift to be delivered. Also detailed the truck, won’t be clean for long ..

 

Beautiful truck! What brand of front bumper is that?

 

During decel or while accelerating?

There is a TSB for a shudder during decel after a cold soak. Which I have. I'll be re-flashing the ECU today.
I have a slight shudder at the same speeds you mentioned (accelerating) but I already have a one piece driveshaft (reg. cab).