Baja Designs: General Discussion Thread

So I have a Question regarding my s8 30” light bar. It’s got the clear lens, but I’m thinking of swapping to to amber. Do I have to buy a whole new light bar for that?

This is my set up:



Looking to swap to this look (amber light bar, and amber fogs)

 

Loving my Squadron Sport fog pods. Picked up a set at the Mint 400 in Vegas and I could not be happier with the quality of light they throw. I figure if they're good enough for Justin Lofton they'll work for my needs

 

Installed a onx6 20” racer edition over the weekend. Light bar is brand new. Ran into a little issue. Only half the light is working. Purchased light bar with harness. Checked with a volt meter and I’m getting 12v throughout the light. Opened the second half to double check and make sure I’m getting 12v. The only thing I can think is possibly just a bad second half of LED’s. @Baja Designs

 

https://www.bajadesigns.com/products/Replacement-Lenses.asp

 

As @EatSleepTacos mentioned, replacement lenses is all you need

We sell them in 10" sections for the S8. A little patience and a M2.5 hex key is all you need.

Baja Designs
www.bajadesigns.com

 

Nice!!! Looking good

 

Please give us a ring at 800-422-5292

It's possible a jumper came loose or the grounds for the circuit board. Our team will help diagnose the issue. We'll happily fix the bar if needed.

Baja Designs
www.bajadesigns.com

 

Thank you. Hopefully we can fix the problem over the phone

 

Anyone running LP6s on here? Got a set coming to be my spots and just curious on what folks thought of the light output. The LP9s are way too massive for my bumper.

 

curious to see what what it would look like, my buddy and i test fitted a lp9 on my brute and his pelfrey a while back -- it was too bulky for the pelfrey and it was too deep for the brute

 

I'm curious, too. I've Been thinking of LP6s for my ARB bumper

 

i think its safe to run any big light on the arb since it has the space, lp9 fills it in better

 

Like. I guess I'll have to go LP9 for the ARB.

 

Hey @Baja Designs , had a brainwave while I was looking at the fog lights on my new Honda Civic Si...

The tabs on it look almost exactly like the 4 holes on your Ford/Subaru pocket kits:


The diameter appears like it might be slightly smaller, but it's hard to measure with the way the body is shaped.


Any chance you know if these mounts might have been standardized across Honda now too??

 

I believe they are very similar, if not identical.

Our R&D department was discussing this vehicle a little ways back. Let me check with them

Baja Designs
www.bajadesigns.com

 

2016+ Tacoma | Lighting Kits

 

Friendly reminder for those that are checking this thread out, This is a Baja Designs General Discussion Thread!

A place to post:
-Product information
-Photos
-Questions
-Complaints and comments

Have our lights or want to know more about our products?
Please post up!

Even if the question has been asked multiple times, feel free to comment below

 

Awesome, thank you! I know that it’s the same mount between Civic Si and Civic type R...

If need be I would be glad to give it a crack if you have a factory second / blemish mount laying around somewhere, I could pirate a square squadron off the truck and see if it works.

 

This thread is one of the many reasons I buy only Baja Designs lights. I find it amazing that a large company like BD cares so much about it's customers that they log onto TacomaWorld everyday just to answer questions. Keep up the good work!

 

Hey Dave, you’ve got a little something on your nose.