Alabama thread!

Damn that dude went nuts

 

So keep the cuts about 2” from the weld to the frame?

Also @tweakit88 they will be for sale. I’ll have to get a measurement on tread left.

 

Sounds about right. Never really measured it. I can measure my block off plate if you’d like a rough measurement.

 

Sure. I’ve never looked at a cmc in person.

 

Mine looks like hot garbage so don’t judge. I personally didn’t do it, had a buddy do it before I could weld. Lol.

 

I just need some temp trailer tires . Im gunna get new tires in november and then im gunna move the falkens to the trailer.

 

Maybe I’m cutting the wrong places, but this things a pain in the ass with angle grinder.

 

Nope. You’re correct. Major pain with a grinder. I cut that in 5 minutes with the plasma. I don’t miss doing it like that.

 

I may just wait and do it with the plasma.

I figured I’d take a stab at it. I’m not the best with plasma, but this is BS.

 

Do you guys ever cut into the circle the bushing is in or you must avoid it.

 

The best from MI I've ever had is Hopslam.

 

I like almost everything Bells brews.

 

Just cut everything but the bushing itself. It’ll be fine.

Here’s mine by the way. Ugly I know.

 

I just planned on cutting as much as possible and never touching again if... IF... I ever go to 35s.

My line went into the bottom circle, I’ll do more with the plasma. Should I cover the bushing or wet it to keep it safe from bubbly metal lol.

 

I never do. Never had one melt. Just cut it with the plasma and point the torch at the area that needs to be cooled after your cut is done. The post flow will put out any fire you have.

 

OME installed

 

We will be in GS that same timeframe. Where you staying?

 

Saw some coffee talk back a few 100 posts. I’ve been experimenting with instant coffee. It’s suprisingly good!

 

Surf and racquet club on the bay

 

@whitedlite here is my cab mount