All In one Remote Key GQ43VT20T

i need that remote key style

 

So question for those using the remote key... I've been looking at one of those remote starts that you push the lock button 3 times and it starts the truck... Was wondering if you had a key like this, could you program the "trunk" button to be pushed and use that as the remote start? Just brainstorming.. If not, then ill just look for a remote key without the trunk button

https://www.ebay.com/itm/Upgraded-F...4-GQ43VT20T-Trunk/293030481460?epid=841820171

 

me too! other than purchasing a key on ebay and than having i would assume a lock smith cutting it, have no idea what else i need to do to get it to fully work on my 2010. some of the stuff in here is confusing.
and i doubt it if i walk into the dealer with the cut key and say will u program this they will even do it

 

I had that same question cause my flip key has a trunk button. Couldn’t find a remote start that could use it so I went with the “lock x 3” style.

 

yeah what i’m looking to do is add the 4 runner style key which has the lock unlock and panic button.

 

would something like this work to program the key i want ? after getting it cut at a lock smith.?

 

i’d want this key as it has the toyota emblem on the back and is factory key.

 

this! ?

 

idont know man. someone here said that you need some software or something else to program it i asked the seller.
if not who can lead me in the right direction i’d love to switch to one key

 

i messaged a local key repair company that does like lost key fobs and stuff like that. They are mobile company going to run it by them see if programming the key is something they can do.

http://www.mylockworks.com/key-fob-replacement/

 

Thanks, Ryan!

 

ok so i asked that ebay seller and he said i could buy the key combo from him and program it with that 25$ device...

 

What needs to be done to run this key, I'm having a hard time understanding. Just buy the key take it to the dealer and have them cut it. Then find someone with a key programmer and get the chipped programmed?

 

we are in the same boat.
this is the key i want.

 

[disclaimer: I'm not an expert but from my experience...] Yes there are three things:
1. Cut
2. Program truck to accept the chip
3. Program truck to accept the remote (lock/unlock)

A good locksmith should be able to do 1 & 2. For 3, see here:

 

i’m still waiting for this company i contacted to get back to me. so i should tell them i have G CHIP key? and want to program another G chip key to my truck?

 

just asked another locksmith who got back to me and i have heard and know where they are located
will let y’all know what they say!

 

@Nateclimb I can point you to the locksmith I used here in Sandy if you’re interested

 

Yes definitely!

 

Action Locksmith, 10919 State St (just north of Harbor Freight). Seems like it’s pretty much just a guy who does locks, and he does good work.