Keystone State Thread

I have some stock fogs, what do you need them for?

 

Also have stock fogs laying in my garage. Have the harness that goes between them as well.

 

Taking off my aftermarket stuff

 

$500 is too cheap for a blonde, something doesn't run right.

 

I completely forgot you’re trading your truck, I actually want to keep my stock stuff for that same reason. Sorry

 

Wanna bet...




@skatefreak282 met her.

 

I'm about 18 years past buying blondes on Craigslist, but I'll hold your beer and the camera.

 

What fog lights are they? Do they have the factory connectors?

 

1000000000% agree what a great dude!!!! Happy Birthday @loosnut

 

Happy birthday @loosnut

 

@loosnut



Have a great day brotha! Definitely the best human I've met from TW.

 

Happy Birthday @loosnut!!!

 

They are morimoto xb led fog lights and plug right into your factory plug

 

Those are the morimoto fog lights. If you want to be extra you can get a set of Lexus fogs to fit.

 

Happy birthday to one of the most helpful members I've met through the forum @loosnut. Have a good one Jerry.

 

Happy birthday @loosnut

I gotta tell you all about an example of how awesome this dude was.

A few years back after takeover, I was on my 3 miles from home (which at the time was a cabin in the middle of nowhere), and my front passenger wheel bearing let go.



Not only did it let go, but it melted the wheel speed sensor, and wreaked havoc in the spindle. I got a new wheel bearing and proceeded to disassemble the existing wheel bearing.



This is where Jerry came in. I was texting him for advice when he suggested I take the spindle off, and try to pound the race out. Well, I didn't have a wrench big enough for the UCA castle nut, and Jerry decided he was going to go out of his way on a Sunday, drive over to my place, pick up a wrench that I needed, and help me out.



He then wouldn't accept anything for payment for the tool (money, beer, food), and then proceeded to pound the race out with a mini sledge and a pry bar to in a circular motion spinning the race out. And I can only surmise that he figured out I was all set and had everything I needed, and left in a flash! Again, I tried to give him anything to repay his time and effort, but he wasn't having it. He literally helped me out of the goodness of his being.

Below is was the finished wheel bearing fix:




Oh, and he helped me with the Ujoints on my old driveshaft a few weeks later by meeting me with a balljoint press and teaching me how to make sure the Ujoint is in correctly while helping me replace that and my carrier bearing.





The least I could do was give Jerry this!



Long story short, he's one of the best people I know. Habby birthday @loosnut !!!

 

Way to make everyone elses post look lame!

 

Happy birthday @loosnut

 

Happy birthday @loosnut