Raleigh North Carolina and surrounding areas

In my opinion if is what it says it is, probably worth close to that.

 

You were the main one I was hoping would see it.

Thanks! Friend of mine is looking at it

 

not $6500,
rusted tail gate suggests there is probably more in the bed, let alone the gate and bed are beat to hell, plastic bed liner hides a bunch more damage i’d bet.
dent/bullet hole in bed side, really ?
left fender pushed back so door tweaks fender and door, left side of cab back looks creased compared to right side...
heavy aluminum oxidation blurred on engine pic (3.slow at that) rusted steel lines and brackets on engine, bet the underside looks really nice with fresh black paint
carpet is trashed, no way that’s coming back
I know the ODO on those isn’t difficult to run back.....

$3000 if it runs well and drives well, no issues with 4wd (manual hubs are a regularly mis-assembled part and causes non-fuctioning front drive, could possibly also cause front to not disengage.
that it has manual hubs

 

Im a Peacock

Preach!

 

This^^^^^^ Pulled many out to discover rusty rotted beds. Those plastic bed liners tend to trap debris and moisture and rub the bed to bare metal then causing rust. One of the worst accessories made for truck beds. Dents and stuff kinda come with the territory on a metal bed.

I would crawl all over really good and check everything over. Agree with some of what Kevin said about rust and hiding stuff. To me that price is a little high for what that truck looks to be. But only seeing it in person can really asses the condition and value.

 

Call Chatlee Boat and Marine in Sanford they can probably get you a front cushion for the bow so the kiddos can comfortably ride up there safely and put some rails up there too.

 

Thanks dudes. My buddy with the 4Runner was looking at it for a daily driver. I’ll pass this all along. I did talk to him about the rust when he first sent it to me. I hate those plastic liners for the same reasons y’all mentioned and am very aware of the rust issues associated with yomtoyotas

 

That’s definitely on the list of things to do. You’re the 4th person to point me to those guys so I’ll definitely give them a call.

Found out my bilge isn’t working either.. so prolly gonna have to stick her in the shop this week to get that replaced.

I did get the new depth finder/gps wired up last night. Stoked to use it lol. Bit of a crapshoot driving the ICW without one

 

Chatlee is the largest CS dealer on the East Coast if not the US. Also they have a fabrication company make their rails and T-tops that are higher quality that the factory stuff. They may have a different company do their upholstery as well.

As for the Bilge pull it off the strainer and see if it's clogged if not check for power back there when you turn the switch on. If there is power it's easy to wire in a new one I would recc. a Rule brand they are a good bang for the buck. You can do it yourself. Just make sure to get either Rule or 3m marine sealant when mounting it and use really short screws so you don't go through the hull.

I've had my fair share of boat projects and boats. Flipped a few and made some decent money. Those Zuki motors are really good for the $$$.

Rule 20R 800 GPH Submersible Bilge Pump, Round, 12 Volt

https://www.amazon.com/Rule-20R-Sub...mp&qid=1561383430&s=gateway&sr=8-9&th=1&psc=1

 

If you’re gonna state “used -like new” it better Damn well be spotless

That truck is trashed for only “97560 miles” 29years old is irrelevant

My 11yo DCSB has 281000 miles and isn’t quite that messed up bed and body,

 

True the advertising is misleading I didn't even read that part I tend to look at the pics and make judgements. But if you are going to advertise it as like new then it better be pretty much showroom quality!

 

We just went to my buddies wedding, were recruited to take pics because the student that he was going to use got a god complex. She wouldn't tell him the price until last minute and then just kept going up on price. "10 gaurenteed pics $100 ontop of her charge to be there and then charge per picture". He told her to fuck off and asked all their friends attending to take pics! My wife and I alone took 1500 pics(after we deleted blurry and bad pics) on nice DSLR cameras, there was another girl with some nicer camera and we had 3 gopros running.

 

That's kool..
I remember a wedding I went too with a bunch of disposable cameras on the tables.. Take all the pics you want and leave the cameras.... there was some questionable pics...

 

Looking a Classic Chevy car for about 10k...
Monte Carlo
Chevellle
ETC...

 

Those tend to be better pics anyway, you’re there in the moment, not the canned “strike a pose” bit.

 

That's rediculous. But y'all probably got better candid pics than she could of and more of them since more people were taking them.

 

Yall ever need professional pics, let me know. I know a gal here in Wilmington that is an amazing photographer

 

We did that at ours.. thankfully, we knew whos cameras were whos and we chose not to develop some of them... mostly from my friends and my side of the family haha

 

So what you are saying is your family and friends are the hoodlums of the group. Note taken

 

Precisely