What Have You Done To Your 2nd Gen Tacoma Today?

Hey coat hangers are cheap make a new one with every new paper towel roll

 

This'll last a while, until metal fatigue from re-bending kills it

 

Guessing with the removal and replacement of my OEM bumper/grill and headlight I could probably use a set of fasteners like these. Anybody have suggestions or warnings regarding these aftermarket clip packs?


...and before it's mentioned, yes I know a welded and fastened bumper would be a better replacement, but I haven't even owned the truck for two weeks yet so I can't justify spending the money before I make my first payment on it.

 

Right on. Thanks for the info. The build never stops out here. def thought the 5100's and 3 leaf AAL would be enough to support a bed rack and RTT + camping gear. My reverse rake although subtle, is so cringy

 

I was bouncing between the EL095R and the EL096R. VERY HAPPY with the 96! If it’s too much you can reduce the leaf pack. I didn’t. I’m at about 3.5” all around. The Westin bar in the pic will be replaced by a Mobtown bumper and winch when I’m home on R&R.

 

Agreed, it is worth it. This is dakars, b110 and +4” brake lines and that’s it. This is my old set up.

https://www.instagram.com/p/Bnb1b6-Hk63/?igshid=1397jzps4hlcs

 

Done earlier but I didn't post a picture:
My lit up CH4x4 switches



Installed white LED's in factory VSC/TRAC Off and RSCA switches (hard to see with the flash).These were the LED's used:

$11 WLJH 10x White T3 Neo Wedge Led 3030 SMD Chip 8mm Base Car Dash Instrument Clock Light Check Engine Transmission HVAC AC Heater Climate Control Lamps Switch Indication Bulb Replacement

https://www.amazon.com/gp/product/B07LCMBSJT/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1



Why does the "Bed Lights" switch stick so far out in this location?

 

Clean install!

 

Those look great!

 

Looks perfect, Bro!!

 

Lower the front end.......

 

It's just amusing to me that the title for the listing is correct "release the kraken" but then they either took a picture of a misspelled part and still used it for the image or photoshopped the writing on, effed it up and still didn't go back and correct it.

 

Cute Asian translations or could it be they want to bag up your Kraken?!

 

Why don't you just go to the local Toyota dealer parts department and tell them you need all the plastic rivets and push pins to do what you are doing

 

https://www.ebay.com/ulk/itm/192899141227

Just a note, it matches the MGM color perfectly, BUT it’s matte and not gloss. When I have the time I will be spraying clear over it to take care of that

 

Can you post video of this mod?

 

Thanks man!!

 

Ya, hyper did a killer job!!