NW WA Meet / BS Thread

I dont think WA does that. Might be wrong, if you ever decide to venture to Juneau AK i can post you to some awesome spots

 

Look what I found out in the mountains today

 

So.....
Where was this exactly?

 

Only reason I was using it was because the battery in my miller died.

 

In Washington I would assume most places with facilities you need a pass.

 

I seem To always switch mine to grind or cut mode before welding

 

I don't care so much about the pass, just looking for a list of these places. They seem to be more hush hush about the camping areas and only list the trailheads and picnic areas on the website.
https://www.fs.usda.gov/detail/r6/passes-permits/recreation/?cid=fsbdev2_026964

 

Cutting fenders....broke my snorkel

 

Whaaa? I thought u already had a snorkel? Did u get a new fender?
Also snorkel plastic can be welder with an electric hot knife tip for a soldering gun. Not pretty but works. Kinda like me.

 

I did, just ordered another one, im replacing both front fenders with flareless fenders.

 

I used the lc80 snorkel on my truck. Took off the antenna(never use the radio) and angled it up some. Fits really well like that.

 

That’s the same one I’m running. I need to re route the antenna elsewhere

 

If anyone has removed the inner fender wells, i highly suggest you pull your fenders off and clean out everything underneath. The amount of dirt will amaze you

 

Yeah it builds up it the top corner of engine bay eventually plugging up the area for water to drain. Mine gets bad.

 

I need to figure out a way to make the buildup not happen any more. At least with trimmed fenders it’ll be easier to clean out

 

Yeah my fender liners and side skirts are gone. That definitely doesn't help the problem any.

 

Anyone up for a little rescue mission? Stuck in the mud at Keechelus Lake

 

I could head that way in about a half hour. 2 ish hour ETA. Can I use my rear winch?

 

My trucks in pieces or i would

@bobsuruncle

 

Yeah I just talked to him. I'm busy for the next few hrs, otherwise I'd be on my way.