What Have You Done To Your 3rd Gen Today?

As in people against it.

 

Yes. Did it to my 2016 as well as my 2019. I like it because it drips out in one place outside the frame rail. So if I see a wet spot I know it’s my AC not something else. Just piece of mind fir me.

 

The front camera cable needs to be routed from the grille somewhere I assume? I figure I’ll get past the first service before messing with that kinda thing.

 

The ol Sequoia took a turn for the worst - structurally / MN rust... classic.. - Loved that vehicle but i bit the bullet and purchased what I had been wanting for a while which is a 3rd gen Tacoma with a 6 spd manual.

 

Yeah. Like when someone says tint for lights or tail lights, they act like that person plans to go completely blacked out. Then all the safety, insurance, and state law guys get in and flame the OP.

 

Congrats on the purchase!

 

Just had some fun driving:

 

Front end makeover, courtesy of a deer with a death wish.

 

Nice! Where at?

 

Just outside Lone Pine, CA

 

Thanks! I’ll have to look it up. Some beautiful scenery for sure! May check it out next time I’m down that way!

 

Thanks much!! Good to be back in a Tacoma.

 

I added a Trxstle rod vault to the front runner rack. I had to make some DIY towers so the vault could clamp onto a bar. Oh and some mofos decided they needed my bike rack more and jacked it off my hitch

 

1. Pool noodle on the tool box to prevent door bangs....
2. Raptor lights for the pro grill cool factor....
3. Redline hood lifts, coz Toyota cheaped out.....

 

Now that's an air freshener I can appreciate!

 

Driving around and saw this today. Pretty clean

 

Upgraded the stock TRD OR Bilsteins with some TRD PRO FOX takeoffs.

Been wanting to do this for a while now and couldn't be happier with the change, night and day difference.
Had some trouble getting the upper ball joint to separate (a hard whack alone just wasnt doing it, needed to get ball joint separator from Harbor Freight and widen it a bit, tension then whack) otherwise an easy bolt-on install.

Didn't weigh the fronts but the rear FOX were 9.13 vs. the Bilstein at 3.12 lbs (+6 lbs).

The stock ride was comfy, but a bit wobbly.
PRO suspension is noticeably stiffer but MUCH more solid.

 

Any sheet metal damage? Its hard to tell in the pic. Looks like you got off pretty easy. Not that ANY damage is acceptable.
I know someone who's car was totaled by a dear running into the passenger door while they were driving.