1st Gen Lunchtable Thread - General Discussion

Other than dogbone mounts on a fwd car you rarely see motor mounts go. Usually to do mounts especially in the rust belt, turns into a lot more broken shit

 

I had the slightly newer CD version of that game with way more modern graphics when I was a kid. Still super frustrating.

 

Think I have a copy for my Apple II, circa 1977. The disk is actually floppy.

 

Oh hell yeah lol. They were part of the anthem of my high school days when they first came around. They had one or two ok songs, before the lead singer went off the deep end. Always thought he looked a lot like Kurt cobain

 

i have been explaining this gremlin rattle to them all these months off and on!

 

my nephew and I were checking them out, there are just 2 on the topside?
the stormclouds were rolling in and started raining before could get a flashlight

 

We rip em in 4 low too :/

I purchased a whole new set for the cruiser cause if that ever started to walk around the engine bay bad shit would happen.

 

Check the obvious things first. Heat shields, exhaust piping, etc. Pull on the throttle cable and rev the engine to look for anything loose.

 

yes we looking underneath at the cat shield and everything in the engine seemed ok but I was trying to peek at the shield in the far backside and maybe was missing a clip but not totally sure what I was looking at

 

Hears rattle*


Turns up radio*

 

i was troubleshooting on the freeway the other day and when i hit 90mph on smooth fresh paved asphalt a vibration started under my feet, it felt serious
engine speed over 3k rpm which I rarely if ever go to unless 5th gear

 

ooh wee those are some pricey parts in that video
over $200 i saw on Timmy's receipt

 

i have turned the radio down to diagnose this issue!

 

Steal me a drivers sunvisor off the blue rav. But only if its tan.

 

Did you take that?

 

this is from that thread of several years ago... has anybody encountered this issue and a fix?
is it something real complicated to fix?

https://www.tacomaworld.com/threads...after-mount-replacement.394647/#post-21002136
"Found the problem. Engine idles around 600 RPM, but I guess the only way to fix it is by replacing the ECM.

Subject: Rough Idle correction for 1995-97 Tacoma with 2RZ-FE or 3RZ-FE engine

Source Toyota technical service bulletin EG006-00 (August 2000)"

 

No

 

I thought so, I was wondering where it's snowing in the middle of July.

That pickup either has the 3.slow or the 22RE. It's probably at capacity with the car on the flatbed, let alone two more behind it.