ETxTacoma's Dynatrac ProRock 60 Rear Build and BS Thread

The housing is a bit shorter, which makes the end appear bigger.

I didn’t realize King’s are circumcised.

 

King's are not circumcised, just the Icons had an enhancement compared to normal average ones....

 

Since my power steering has been acting up again and after doing a power steering flush a while back and putting DexIII in it I noticed that the fluid was a lovely dark sludge once again...

So yesterday I decided to say screw it and drain the reservoir again but this time completely remove the reservoir and fully clean it to make sure that there was zero dirt, debris, etc in it.

Since I could never find a solid answer on this and only came across stuff for 1st gen tacomas about how they had a screen / filter in the reservoir, here is my conclusion for the 2nd gen tacoma...



Pretty sure there is a screen / filter / mesh / whatever you want to call it in the power steering reservoir of the 2nd gen Tacoma, so hopefully this will help someone else out down the road and maybe now that I have cleaned mine and done another flush, it will help my power steering out... because only thing left for me to do will be to replace the power steering pump.

I have also learned what not to do when doing a flush, once again and made a mess once again with PS fluid...

 

Got the rear kings installed yesterday. Fronts should be here by the end of the week and will get those swapped over, also ordering new wheel bearings and going to go ahead and do some gusseted spindles while I am at it plus some other things... so slowly getting these things taken care of.

 

@Wheeler's Off-Road Inc

UPS is being dumb and decided not to continue the shipment of the shocks in SLC even though they both arrived at the same exact time, so right now it is saying one shipment arrives tomorrow and one shipment arrives Monday.

 

@trekker

 

Somebody wasn't getting notifications

 

No I was... I saw them...

 

Me, I wasn't getting them. I missed a ton of updates in your thread and others too.

 

Weird, prob because you had not visited the thread in a while. That happens to me a lot, unless I go and look at a thread I will stop getting notifications for it after a while.

 

If you get a notification, and clear it without going to visit the thread, you don’t get another one.

 

Fo sho, I may have done that accidentally some months back

 

Separation sometimes occurs when they throw packages on routing belts and they scan wrong or find the wrong trailer and get re-routed. Which then delays the whole process. It happens with leaf springs constantly at major hubs. And there is nothing we can do unfortunately.

 

https://www.autoanything.com/resources/stevens-trail-ready-tread-lightly-2014-tacoma-build/

 

That's tight, good job Stevo.

 

If only you sold truck balls to help him complete his build

 

I need to find you an orange set of truck nuts for how often you talk about them

 

Make it happen

 

Ohhhhh snap! That is awesome man! Thanks a ton for the feature! Someday I may make it out to Cali and will have to buy you a beer!

Thanks man!

Please do... please do.

 

@hoarder23 buy me a set of truck nutz and I will throw them on there just for you....