What have you done to your Tacoma today? 1st Gen Edition

I would do the easy thing, pull the front driveline and continue down the road. A front bearing should squeal and affect steering, same with shock bushings. Good luck, hope its the cheapest easiest thing.

 

Yeah I'm going to leave them off till they are ready to go. What did they charge you to fill them?

 

My Fox 2.5 10" coilovers were charged to 250psi

 

Sounds wheel speed dependant. Maybe you lost a wheel weight or two?

Or maybe some broken wheel studs.

 

What did it cost you?

 

My bad, read that wrong. $10 for the 2. Guy brought out a Powertank n charged in less then 2 minutes.

 

Nice I may just wait till next Tuesday and take them in for $10

 

I’m in strong agreement with this. Interested to try out the Nitrochargers though

 

I think this is the way I’ll go if I ever decide to replace my dead Billy’s.
But who knows when that’ll be

 

I’ve been meaning to install mine. It’s plug-n-play from what I’ve read on 2001-2004, however since the cruise control changed in 2001 the cruise control stalk on the IS300 wheel isn’t compatible on 1995-2000. This can be fixed by simply swapping the resistors on the stalks, there’s only three of them.

Five minutes with a soldering iron probably.

I also snatched the clockspring because I wanted the trans shifters to control track up/down and volume up/down instead of shifting the transmission. Easy to do with some additional resistors and a stereo interface.

If you don’t care about cruise control or the shifters it’ll bolt right up to your steering column. You just have to do a little repinning to get the horn to work.

The IS300 is a desirable steering wheel swap because the airbag squibs are the same. It isn’t the dual stage charge found on most other Toyotas. Only a few vehicles of the era still used that old single stage squib, including the IS300 and RAV4.

 

Do you know what years of rav4's will work ?

 

01-03.
Not my pic

 

Not sure. It’ll be early 00’s models.

 

Any luck figuring it out @Ace115?

 

i followed a 3rd and 2nd gen down a nasty Wisconsin forest trail this past weekend and got the fckng scratches never before I have seen
hope they will buff out or oh fckng me shit

 

You should see the sides of my truck....they're just trail pinstripes, nothing to worry about. The bright red paint hides them pretty well though

 

Yeah the 01+ has different end links all together. All your gonna use is the big red c shaped ones.

 

If you have sway bar end links like this: those won’t work

 

Get em from napa. They have wrench flats on the backs so when that allen hole strips theyre still easy to get off.