1st Gen Lunchtable Thread - General Discussion

I stripped a 12mm using sae earlier

 

Idk if anyone has seen snowpiercer but they are making another one

 

I was at pick n pull and wasn’t trying to walk back to the truck for my metric kit.

 

Replaced expansion valve and o rings as well as the orings on the high/low line connection to the engine bay. @Sperrunner should I expect the vacuum pump to peg out the gauge at 30psi vac? It's at 23~ish

 

I don't think this ARB twin is gonna fit in the engine bay like I'd hoped. Not sure I want to mount it in one of the backseat cubbies due to airflow and heat concerns though

 

THrow it in a bag in the tool box

 

Apparently there is 4 idle adjustments in my van. One is a dial on the ecu, one is a set screw in the throttle body and there is also a iac

 

Install inside between the bed and fender then run a port into where you fuel for gas

 

Sheesh

 

Not a bad idea. I don't want it to get showered in dirt and water though. I don't have inner fenders since they got nixed for 35s

 

If it fits, stick it in there

 

I was thinking about mounting it inside an ammo can or tool box and making it portable til I figured out where I want it permanently

 

Yeah that works

 

Sitting here, drinking a beer, waiting on the succ

 

You gotta admit, it is a good looking taco

 

Can hardly tell it even is one! Thanks man

 

Vent a ammo can and mount it up there or under the bed

 

You should see his house. It’s more Oriental than mine.

 

Please for the love of god, rip out the leprosy from your hood.

 

This guy is great.