What Have You Done To Your 2nd Gen Tacoma Today?

How was the install..? Plan on doing this same thing in the spring.. 285 and 3.73 suuuck

 

Tinted front windows and plasti dipped hood scoop insert

 

tried.... but failed. got one of those novelty fog light switches. can’t seem to find the right combo to wire it in place of the stock switch. any suggestions?

i get the fog lights to go on and off, but the switch leds don’t illuminate when they’re supposed to. then i can get the switch leds to go in and off, but the dogs don’t work.

 

My truck was backed into and I need your help on deciding if I should stick with replacing the stock front bumper or go with this hybrid off road bumper? I like the look of both and I can’t decide. I need some input

 

You have conflicting wiring diagrams. One has 12v switched to relay and the other switches relay to ground.

 

I've wired a few of these types of switches into my truck. You need to tap the yellow wire into another lit up dash switch. And the ground needs to be tapped into the dash swich ground because they ground through the dimmer switch. The ground wire is only for the switch LEDs it has nothing to do with the fogs.

 

Took this cool picture today

 

I vote hybrid, I have one and I love it! Also gives you better approach angle and can take a hit from a car or a rock lol

 

Turned it into a fuckin space ship.

Finished up the roof rack pods today.

The above photo is 4 roof rack pods, rock lights, ditch lights, bumper bar, roof bar, and retrofits.

 

Pic don't dew justice

 

iPhone 6 camera is kinda useless at night.

 

sorry, should have clarified the first diagram is of the stock wires. the second is of the new plug wires. i thought it was going to be plug n play, guess not.

 

I vote factory with US Offroad WINCH bumper.

 

to use the oem harness you need an oem switch, as you can see the wiring is different and the two switches aren't interchangeable. You could us the new switch buy only with all new wiring.

 

yeah got it. thanks.

 

Installed a tailgate damper (EZDown) ... works as advertised, but the able is getting in the way a bit. Anyone have any experience with one of these?
Also trying out a DIY mod to address the constant steel-on-steel impact (and powdercoat damage) for my swing gate when opening/closing the latch ... have a small piece of rubber around the latch and post, have to see how it'll hold up.

 

Aren't pivot points like that usually just greased?

 

The round bar in the picture sits in the cradle, the latch swings around that. The latch moves freely, but when it locks in, it's coming in contact with the metal and scrapes a bit. Over time, the powder coat has worn away. I don't recall it ever being greased.

 

Snugtop uses a similar idea on their rear hatch latches so I suppose it could work. It's obvious the paint won't sustain the wear.

 

I'd check/complain to the manufacturer, but they're no longer around so ... ¯\_(ツ)_/¯