MESO Customs 3RD Brake Light housings

Yesssssss please!

 

Yeah man bring em' on! When do you think you'll have them ready?

 

Subbed

 

Patiently waiting to buy a KC5.

 

I'm in for a 2nd gen sir

 

Yesssss!!!!

 

Yes BD3 2nd gen.

 

Ready and waiting!

 

Yes Please.

 

4 cyclone for 2nd gen. I’m ready

 

@Tommyb08 here we goooo! Lol

 

So I have a 3rd gen accesses cab, I need the 2nd gen brake lights correct?
And is there a way to get a cargo light to wire to the dome lights? Or plug into say my puddle pods ?

 

ready to buy as soon as you're ready to sell.

 

@Cav_BluTRD I'm installing my Meso thinfin tomorrow. Planning on running three sets of Baja S2’s and a solar panel on my Prinsu. Any tips or tricks? How was it drilling the hole in the internal antenna? How did it go attaching it? Does it just screw on from the inside? How did you seal the holes where the wires go? Silicone? Thanks in advance for any advice you can offer.

 

Make sure you pull ALL the components out of the shark fin. I forgot my radio antenna and have to do it over.
Attaching it is easy. Just the screws swap over and boom done.
You don’t need to drill a hole in the antenna. Just though your roof. That’s the worst part. Blow off or clean off all the metal shavings or else they stick around on your roof. (Ask me how I know) I used clear nail polish to seal the paint around the hole I drilled.
I used RTV to seal the holes, but somewhere @MESO posted a picture of rubber grommets that fit in the holes, I would go that route.

 

Correct on the 2nd gen housing for 3rd gen AC.

 

@Cav_BluTRD Thanks so much for the info! Do you have a pic where you drilled the hole? Was it at the front or rear of the existing hole in the roof. Obviously under the thinfin itself. On the thinFin did you use sealant around the bottom or just rely on the rubber gasket?

 

I used the stock rubber gasket. No leaks over here. Been in multiple hard rain storms.

Judging by my shitty picture I must have drilled behind where it normally mounts.

 

@Cav_BluTRD thats great thanks. How did you get the that huge radio antenna in the tiny fin? I have it all apart now and scratching my head on this one.

Edited to add. Got a hold of @MESO and it can’t be reused. Reports say functions as normal. Good enough for me!

 

I haven’t done that part yet lol
I think you need to undo the screw on the upper part of the shark fin and wrap it around or something. @upTOPoverland or @MESO might know better.