New England B.S. Thread

Thanks man.

Thanks man. Appreciate the thoughts.

 

No sweat

 

It's a drive from you, but Taunton Animal Shelter in Taunton MA is where I adopted my cat Ozzy from..they have dogs as well. Very nice place, and a no-kill.

 

We got one of our dogs here.

https://www.secondchanceanimals.org/

Well run, well managed shelter.
They bring a lot of dogs from the South.
All kinds of mixes, if you don't find one to your temperament go back in a week or 2.

It was about 10 years ago for us. If I remember correctly Puppies are more expensive than older dogs.

Check them out.

 

Started replacing the brakes in my wife’s GMC Terrain....4.5 hours to get the DS rotor off. I shit you not. It was down hill when the tire was seized on too. Original brakes on a 2016, pads actually aren’t bad but rotors were pretty beat. I have never felt so defeated before in my life hahahaha rust was so built up around the hub I broke it off the face but had to pry and beat the shit out of it to get it off. Had to put off the PS for the next day or two. This is the first time I haven’t dealt with rotors with tapped holes to use bolts to pop the rotor off.

With my luck the PS will pop right off like nothing happened. I honestly almost called in an SOS with y’all for any possible assistance I was so close to tapping out but obviously once you start smashing the face of a rotor with an Estwing there really isn’t any going back lol

 

Yea but an excursion was like an HD SUV. And if I could the expedition would definitely have the coyote 5.0 but the turbos should be helpful in the mountains.

 

Appears my coolant bypass tube no.1 is seeping/causing air to get into my cooling system

 

That blows, thankfully the replacement part is not to hard to change, just have to take the intake manifold off to get to it .

 

Plugs work great and don't forget a compressor.

 

Haha you got it. You did great on that ride.

 

saw this one in damariscotta during a prison transport... anyone here? Mass plates....

 

Should have pulled him over for being too clean! Love striping when done well like that. Good catch!

 

Just got my 4wheeler into the truck bed. Wasn't sure if it would fit length wise or even width wise really since the wheel wells take a decent amount of rear room. It works, but its close!

Don't think it'd work on a short bed, though it might, I lose about 8-10 inches with my tonneau rolled up and there are still a few inches on the back.

 

haunted VT Trip? Do explain...

 

Anyone have a stock TRD-Off road wheel (2nd gen) available for a reasonable price? I was in for a balancing this weekend and they said i had a hole out of round. Thanks!

 

Wheeling out here around Halloween

https://en.m.wikipedia.org/wiki/Bennington_Triangle

 

Please keep me informed

 

Morning all. Happy Monday.

 

I second that...haunted wheeling sounds sick

 

I think it’s time to start researching leaf packs, the helpers are consistently overwhelmed...
I like wheelies on bikes, not so much trucks.