Show off your aux fuse panels.

What battery terminal connector is that i like The digital reference?

 

This looks like it.

$19 Xscorpion DBT024RP Platinum Digital Battery Terminal with Screw Terminals for any AWG Wire

https://www.amazon.com/dp/B001RRU726/

 

That looks like it. It came as part of a big 3 upgrade group buy that a member put on here years ago. I never hooked up the display so I can't say anything about it's durability. The clamp hasn't given me any issues at all. Works well.

 

Thanks and thought so.

 

Best place to buy panel for fuse block? I have 3rd gen auto. I am going to install the 5032 split panel. So I will be installing two breakers

 

May I ask where you purchased the plate to mount your panel. I have 3rd gen auto.

 

Looks like he got it from powertrays

https://www.powertrays.com/collections/3rd-gen-tacoma

 

Thanks, man those panels are expensive. I have to look into making my own. Thanks for the help

 

Look up (@paranoid56) paranoid fabrications, they are in the $25 price range. That’s close to what you would spend making yours unless you have scrap laying around.

 

You are correct, I made contact, will see if he still does them, Thanks

 

https://www.paranoidfabrications.co...oma/products/3nd-gen-tacoma-fuse-relay-holder

 

Try a scap yard. I found a piece for about $6 that had some bends in it and was able to cut my panel plus several other parts from it.

 

I found a piece of aluminum in my shop. I will go up with some card board and make a template

 

Installed an aux fuse box. Busman breaker and Blue Seas fuse box. Used 12 gauge wire. Only issue was getting the bracket to “seat” correctly. And, I cross-threaded a bolt when installing the bracket. I’ll clean up the wires and fix themount tomorrow.

 

Some things to tighten up but getting close to being done

• Odyssey Group 31M
• Pelfreybilt Battery Cage
• PowerTrays Mount
• Blue Sea 12 Fuse Block + Negative
• Blue Sea 187 Series Circuit Breaker 100A
• Blue Sea Systems 5191 Fuse Block Terminals
• SDHQ HD Billet Battery Terminals
• Homemade Wire Harness

 

Awesome job! Nice, clean, expensive

 

Just wanted to ask, how many of you ran the negative from the panel back to the battery. I know some used the chassis . I am thinking of doing both.
I purchased the Bluesea 5032 which has a split bus.6 circuits hot all the time, the other 6 are switched (accessory). I needed this for a dashcam hookup. The hardwire kit calls for a hot and a accessory.
So I am curious about the negative cable if some can chime in here.

 

I ran it back and shared the same ground as the battery - to the chassis.

 

For one don’t do both. I used the chassis ground, no issues. But I run a Bussman and all my accessories ground out on the body elsewhere, so only small current running to ground is my relays.

 

@Blais03