285/70/17’s

No I don't rub but I did alot of cutting, CMCing, trimming, etc months before. IMO there's no point in mud flaps if you don't have them cover the whole tire. I have 1.25" spacers on my wheels and was starting to get little blemishes on the paint so I went with XL. Having said that you can adjust the XL further in if you want to.

 

Doesnt the cmc take away one of the inner mounting points for the rokblokz? Did you re drill that?

 

@sorgon82 that was my thought also. I have zero rubbing and CMC done. Wasn’t sure how they will mount up with CMC but apparently can do it so they don’t rub. I’ll figure it out next week.

I’m running 285 falkens and Ray 10s

 

No there's another hole. I just used the supplied bracket backwards.

 

Thanks! doesn't look to difficult to accommodate. Looks like you trimmed the flap so you could pull it back for clearance. Surprised you didn't cap the the cab mount..

 

I have the plates...just never got around to getting someone to weld them. It would just make things clean there, no other function.

 

Oh shit your right there is another hole. Looks like it'll work just fine!
Pre cmc

 

Yup, just place the little bracket backwards if you need to. So that the short end is bolted to the flap. I think I also used one of the spacers.

 

Any issues yet with the RC strut system?? Any vibrations ect.

 

None so far and I already have 20k miles on the truck in less than a year.

 

Garmin can you show a pic of the bull bar or light bar on the front.

 

I like it, very nice. Thanks

 

Sometimes it get to the point well sure, they'll fit, but still look stuffed into the wheel well. These would look good with the 285's and a good 3 inch lift. Just looks like they are crammed in there. Suprised no rubbbing